On the 3.5L it is inside the front of the engine, driven by the timing belt.
On the 3.5L it is inside the front of the engine, driven by the timing belt.
It is under the timing cover on the front of the engine.
Yes, there is an access panel.
To remove the fuel pump from the access panel on a 1995 Chrysler LHS, first, disconnect the negative battery cable to ensure safety. Then, remove the access panel located in the trunk or under the rear seat, depending on the model. Carefully disconnect the fuel lines and electrical connector from the fuel pump. Finally, unbolt the fuel pump assembly and lift it out, ensuring to handle it gently to avoid damage.
i just got that code on my 95 Chrysler lhs, and it means the throttle position sensor (tps) is bad or the wiring to it.
six pin square plug under the dash on the driver side.
No, Chrysler does not use inertia/reset switches.
Yes, I can.Yes, I can.
how to remove a water pump on a 95 infiniti g20
Where is the water pump in 95 lincoln Mark 8?
Chrysler/Dodge/Jeep vehicles do not use inertia/reset switches.
In a 1994 New Yorker, there is a round panel under the rug toward the back seat. You can pull the carpet from the seat edge and peel it back to expose the panel. then there are four screws that let the panel come off. I would guess the 95 lhs would be the same, the cars look the same.
change water pump 95 Honda civic ex