On a 2007 Jeep Compass, the wheel speed sensor is typically located near each wheel hub, mounted on the wheel bearing assembly. It can usually be found on the front and rear axles, often embedded in the brake assembly or along the axle shaft. To access the sensors, you may need to remove the wheel and brake components, depending on the specific location of the sensor. Always refer to a service manual for precise details and safety instructions.
The 2007 Jeep Compass has front wheel drive.
The 2007 Jeep Compass has a 8 ft. 7.7 in. (103.7 in.) wheel base.
Nearside front wheel bearing
left front wheel
The 2007 Jeep Compass has a 5-speed manual.
The speedometer signal comes from the abs wheel speed sensors. They are located on the top of the rear axle and at each front wheel bearing.
It is a code for a faulty right rear wheel speed sensor.
You can not flat tow a Compass with all four wheel on the ground.You can not flat tow a Compass with all four wheel on the ground.
The speedometer/ odometer signals come from the ABS sensors. There is a sensor at each wheel bearing.
I'm not positive about this particular car, but on most cars the speed sensor screws into the transmission.
On a 2007 Jeep Compass, the bank 1 sensor 2 (which is the downstream oxygen sensor) is located on the exhaust system. Specifically, it is situated after the catalytic converter on the driver's side of the vehicle. To access it, you may need to raise the vehicle and work under it, as it is mounted on the exhaust pipe.
Speed sensors are located on the axle