where is the input and output speed sensors located on a 2002 Dodge Intrepid?
is that way the speedometer don't work?
Read more: How_many_and_where_are_the_input_and_output_speed_sensors_located_on_a_2000_Dodge_Intrepid
the input and output speed sensors are on th driver side of the transmission located one on each side of the dipstick
The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.
There is one of each and they are located on the left (or driver's side) of the transmission. The front one is the input sensor right by the dipstick tube, and the rear one is the output sensor. Must be careful when tightening the new ones since the are plastic.
They are on the driver's side of the transmission, and require a 1 inch deepwell socket to remove, and you may need some extensions to reach it.
The three sensors are [input sensors] that are wired to the Transmission Controller to give speed information to the Controller for proper shift points,[up-shifts-down shifts Input Turbine Speed.... Output Turbine Speed.. Vehicle Speed sensor...
There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.
They are the two wire sensors screwed into the front of the transmission case.
The Vehicle Speed Sensor will be on top of the transmission, at the transmission output. Wheel Speed Sensors will be located at each wheel.... the latter are for ABS.
They read the speed of the input and output components of the transmission.
On a 2004 Jeep Liberty with a 3.7L engine, the input and output speed sensors are located on the transmission. The input speed sensor is typically found on the transmission near the torque converter, while the output speed sensor is usually positioned near the rear of the transmission, towards the tailshaft. Both sensors play a crucial role in monitoring the transmission's performance and communicating data to the vehicle's engine control unit.
AnswerTry replacing the input and output speed sensors located on the left side of the tranny and reset the computer. They will run around $40 to $50.
In a 2001 Nissan Frontier, the automatic transmission speed sensors are typically located on the transmission itself. There are usually two sensors: one for output speed, located on the transmission tailshaft, and another for input speed, found on the transmission case. To access them, you may need to lift the vehicle and remove any undercarriage components that obstruct your view. Always consult the vehicle's service manual for specific details and diagrams.