On a 1986 Oldsmobile Delta '88, the oxygen (O2) sensor is typically located in the exhaust system, either in the exhaust manifold or just downstream of it, before the catalytic converter. To access it, you may need to raise the vehicle for better visibility. The sensor is usually threaded into the exhaust pipe and can be identified by its electrical connector.
on throttle boyy in corner
195 r60
To install the throttle position sensor (TPS) on your 1986 Oldsmobile Delta 88, first disconnect the negative battery terminal to ensure safety. Then, locate the TPS on the throttle body, remove the screws or bolts securing it, and detach the old sensor. Position the new TPS in place, secure it with screws, reconnect the electrical connector, and finally reconnect the battery terminal. Make sure to adjust the sensor if necessary, following the manufacturer's specifications for voltage or resistance.
On a 1986 Oldsmobile Delta 88 Royale, the fuel pump relay is typically located in the fuse box under the dashboard on the driver's side. You may find it near the center or towards the front of the fuse box. For precise identification, refer to the diagram on the fuse box cover or consult the vehicle's service manual.
ECM is a common problem with this type of car engine
go to OBD codes.com they have them for everything sandi
Lap and Belt
osmobile delta88
I
On a 1986 Oldsmobile Toronado, the oxygen sensor is typically located in the exhaust system, specifically in the exhaust manifold or just downstream of it in the exhaust pipe. It may be mounted on the driver's side, near the engine. If you're having difficulty locating it, consulting a repair manual specific to that model can provide a detailed diagram and additional guidance.
Probably cable
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer