the only thing i could think of is a bad speed sensor, but that's only if its the odometor and speedometor. if its everything, then theres a bad commection or possibly a fuse.
You Don't.
The engine computer is the regulator.
One of the gauges is outside the safe range. Check oil pressure, coolant temp, and battery voltage.
They are five inches in diameter, I accidently purchased six inch speakers for my lebaron and found that they were five inch.
well it all depends on your engine, but assuming you have the 3.0, id say it would top out at 110 - 120 mph on a flat road, it has 140 hp
On the inner fender on the drivers side. Will have two connectors (one large) .
the ground for the guages has worked its way loose tighten the ground for the guage cluster.
The Chrysler LeBaron first went into production in 1931. It was the Chrysler Custom Imperial Eight. This is the earliest mention of the LeBaron name associated with the Chrysler company.
in the dash
No, the engine doesn't have to be pulled to change the water pump.
It depends on what is causing it. This light usually comes on when the car dies, the oil pressure goes to zero, the water temp goes into the red zone, or the volt gauge goes to high or low. One of your gauges should be inoperative or showing an incorrect reading, or you have a problem with the engine for this light to be coming on.
no boot for 93 is 90-95 look on eBay orchrysler parts for 89 Of course it fits, without any restriction, all boots are the same from 1987 up to 1995, but Chrysler uses other part numbers!