answersLogoWhite

0

It is either the WRONG seal or the tailshaft bushing is worn out. Replace bushing and seal.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Why does a 4L60E rear seal keep going out?

The front driveshaft yoke slides up into the seal and also into a bushing. If the bushing is worn, it will eat up a new seal quickly and start leaking. Check for side to side play or lost motion between the yoke and bushing. If there is any, replace the bushing and rear seal. Also look for a good clean smooth surface on the yoke slider. Also check for a bad U-joint that will cause driveshaft vibration and lead to bushing wear.


How does an rear crankshaft oil seal operate?

The job of the rear main seal is to keep the oil lubricating the rear main bearing from leaking out. Older model rear main seals were made from a "rope" type of material. Today the rear main seal is a one or two piece seal made from neoprene rubber and is located directly behind the rearmost main bearing journal of the crankshaft.


Why does the transmission seal keep popping out on my 1983 Chevrolet Camaro I've replaced it twice?

Check the vent on top of the transmission as it may be building up pressure and can not vent it.


Where is rear crank shaft seal?

The rear chankshaft seal is on the back end of the engine above the pan and at the rear of the crankshaft.


How long change rear main seal?

Not enough clear information ! - Rear main seal on WHAT - ? ?


Chevy 350 rear main seal?

Yep, they have one. 1986 and older has a two piece rear main seal. 1987 and up has a one piece rear main seal.


What is the most common rear trans seal?

How do you change the rear main seal on an 1995 eagle talon?


How do you change a rear main seal on a 350?

how do you change a rear main seal in a Chevy 350 motor


How do you chenge a rear main seal in a 97 Toyota Camry 4 cylinder?

remove transmission, remove rear main seal, install new rear main seal, install transmission.


Is the rear main seal rope or rubber seal?

Rubber.


How do you repair a Rear seal on a 85 c10?

Remove the you joint and driveshaft. Remove the rear end seal plate. Remove the seal and bearing. Reverse the process to install the new seal.


How do you replace a Ford F-150 rear axle seal?

how do you replace a Ford F150 rear axle seal

Trending Questions
What is the psi on the fuel pump on a 1997 s10 truck? 2006 Jeep Liberty both Stop lights not working? Reset button on 1999 Chevy Suburban? What would make a truck run fine in the morning but not in the afternoon? Why would a small block Chevy have forty inches of vacuum at an idle? What is the firing order for a 1996 Pontiac Grand Prix? Will a broken serpentine belt keep your 1985 Chevy S10 pickup from starting? Where is the master cylinder located on a ford tarus? How do you remove the sub woofer from a 2000 Mercury Mountaineer? What might be the problem if a rear left speaker doesn't work but all the other speakers work fine in a 1995 Chevy Blazer? Is a 2000 s10 2.2l head the same as a 2002 s10 2.2l head? Why would a 2000 Chevy Impala shut down while driving and then start back up a few minutes later? Where is the shut off relay in a 08 dodge avenger 2.4? Is there a diagram for replacement of the belt for a 1988 Lincoln Continental 3.8? How do you remove the crankshaft pulley from a 1998 ford contour 2.0 4 cylinder? Why in a 2000 grand caravan front ac does not work but the does? I have a 2004 Chevy Avalanche and i was wondering how can you make your cds so that the name of the song will show on your led of your CD player? Where is the location of the turn signal flasher on a 1996 Pontiac Grand Prix? How can you tell the difference between the high pressure port and a low pressure port to recharge the aircontioner in a 2003 Chevy silverado? How to replace rear wheel bearing ford windstar 1999?