0
What else can I help you with?
What happens if the crankshaft position sensor goes out in a 2001 Oldsmobile intrigue?
The engine won't start.
What causes 1999 oldsmobile intrigue to lose power?
We have a 1998 Intrigue and I can tell you why we were losing power and it was getting kinda' scary, although it would start right up again after I pulled over, put it in park and restarted it. We had an oil leak and it was dripping on to a sensor.
2002 Oldsmobile intrigue hard to start and stalls occasionally?
Its either your cam shaft position sensor or the crank sensor.
I have a 1999 Oldsmobile intrigue and the fan does not work at all no ac no heat no nothing?
I would start by checking the fuse, the relay, and the connector on the blower itself.
Is it possible that my security system causes my 2001 Oldsmobile intrigue to not start?
It IS possible. Tell us more-- does it crank over? Have you checked anything else?
Why is Saturn Ion getting harder to start.?
Tune-up?
What passlock system is on a 1999 Oldsmobile intrigue?
The 1999 Oldsmobile Intrigue is equipped with the Passlock I security system. This system uses a resistance-based key to prevent unauthorized vehicle start-up. When the correct key is used, the ignition module recognizes the resistance value and allows the engine to start; otherwise, the fuel injectors are disabled. If the key is not recognized, the vehicle may enter a security mode, preventing it from starting.
Why does the 2000 Oldsmobile Intrigue sometimes click under the dash instead of start and it is not a battery problem?
Neutral safety switch going bad? Starter solenoid going bad?
How do you shut off the security on a 1999 Oldsmobile Intrigue?
Its in your manuel. Turn key to start wait ten mins and then turn off then turn on it should reset. if not take to dealer.
How do you fix window wiper motor on Oldsmobile intrigue?
Your question is kind of vague, but I would follow this guide: http://redhouseon7th.com/redhouse/howto/2009OldsmobileWiperRepair/index.html as a start at least.
Why would the heater fan blow on high and not on low on a 2001 Oldsmobile intrigue?
The resitors or contacts to the resistors have quit. Start at the switch, check continuity/resistance on the input and output for each speed.
How do you replace wheel bearings in a 2001 Oldsmobile Intrigue?
To replace the wheel bearings in a 2001 Oldsmobile Intrigue, start by safely lifting the vehicle and removing the wheel. Next, detach the brake caliper and rotor to access the hub assembly. Remove the hub assembly by unbolting it and carefully pulling it off the spindle. Finally, install the new wheel bearing by reversing the process, ensuring everything is torqued to spec and properly aligned.
