shift module on side of trans. Mine does same thing and shifts super hard when light not on. Cut off vehicle and crank again until light comes on. Taken mine to shop at least twice and the problem is really sporadic so they couldn't get it to do it and refused to fix it if they couldn't witness the problem which is trustworthy in a shop
If your ABS light indicator is not coming on in your 2004 Toyota Highlander model car even when you start the ignition it might be an issue with the electrical system.
A common cause for an ABS indicator light not coming on in a 2004 Toyota Highlander even when the ignition is started is electrical issues.
Start with fuses then bulbs then wiring.
1. You have a problem with the cruise control. or 2. If your check engine light is also on, get the code read, cancel the light and the cruise indicator light will probably quit flashing and the cruise will start working again.
It means that you need to check error codes for the car computer. It the lights are coming on only when you start the car but then come off. That's ok. But if they stay on you have to check the owner's manual to figure out what to do next. Some light are not dangerous, for instance, windshield fluid light, or break light.
I had the same problem on my 1999 Windstar. It turned out that the light bulb for this indicator was burned out. I simply replaced it and the problem was solved!!
it starts but the oil light stay on
its a rear bulb failure indicator if it comes on when brake is first depressed it is a brake light bulb if it is on when you start the car it is a ride light or park light
Take it to autozone and have the altermator checked out for free. It is probably bad.
Turn on the ignition but do not start vehicle. Your engine and oil light will come on. Press on the accelerator three times and hold it down until oil light disappears. You have reset the oil life indicator.
like what it looks like??.....if so,when your driving the green drive light will start blinking on ur dash
To reset the oil indicator light on a BMW 335i, first turn on the ignition without starting the engine. Press the gas pedal fully three times within ten seconds. After that, turn off the ignition and then start the engine to check if the oil indicator light has reset. If it remains on, repeat the process or consult the owner’s manual for specific instructions.