You sound like you have the same problem I had. The shift lever has a linkage that overtime can stretch. When you put the car in park, wiggle the shift lever until you hear it click. Then you can remove your key.
The neutral safety switch is bad, the ignition does not recognize it is in park. Your ignition switch may be bad.
TRY TURNING THE KEY OVER.
you dont,
No i have a 2002 malibu that had the same problem when i checked it was the park lock switch that was causing it
there is no Chevy town and country. its a Chrysler.
how do u disconnect the cable from the back how do you remove the ignition switch from a 2001 Chevy Malibu you have to put the old key in the ignition. then if you feel around on the bottom of the assembly you will find a small almost rectangular button. depress this and then proceed to turn the ignition clockwise. this will move it to the right position and if everything works correctly it will just slide out.
For a 2001 Malibu, you leave your key in the ignition switch turned to the accessory position for 10 minutes. Turn the car off after that and then start it up like normal.
You need to take the dash apart to get to it. I had the same problem in my 2000 malibu. Are u having a theft system problem? I was. You need to take the ignition apart too. Your going to need to reprogram the new ignition lock cylinder with your computer. To reprogram just turn the key to the on position (dont start it) let it sit for 10 minutes, repeat this 3 times. It should be programmed now. Now start it.
Turn ignition switch on ,(don't start car) for about 10 min that will disable theft system.
No, they are not.
To reset the change oil light in a 2007 Chevy Malibu, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After the third press, the oil change light should flash and then turn off, indicating that the reset is complete. Finally, turn the ignition off and then start the engine to ensure the light remains off.
It was part of a recall.