answersLogoWhite

0

Replace the pull=down switch to fix.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the window motors for 1993 buick skylark?

You may as well change the whole mechanism. I've seen them on Ebay pretty cheap. Around $50. The motor itself has pop-rivets holding it down. You'd probably spend as much money on tools as you would replacing the mechanism.


1993 Seville The antenna motor works but the antenna still will not go back down?

The mechanism inside the box is stripped.


How do you get the seat down from the older cars like a 1993 Buick Regal?

Hey Brandon==The seat track has to be specially made to do this. GoodluckJoe


What would be the problem with your 1993 buick lesabre if when you start to push on the gas and it bogs down and has no pick up at first?

Fuel filter or PCV valve? or it could be a weak fuel pump or a bad injector


What happens when the master cylinder goes out in a Buick Skylark?

When you press and hold the brake pedal it will slowly move to the floor. It can also have a catastrophic failure and go straight to the floor with no stopping ability at all. If you hold the brake pedal down and it slowly moves to the floor any at all, replace the master cylinder.


Why does the engine of my 1993 Crown Victoria shut down while driving I've changed sensors and fuel pump.?

Check the M.A.F. ( master air flow ) on the intake. This could be a factor.


What causes bad idle in 1997 Buick park avenue ultra?

what is the down side of the 1997 buick park avenue


What are the release dates for Down the Rabbit Hole - 1993?

Down the Rabbit Hole - 1993 was released on: USA: 1993 (Burbank, California)


How do you fold down the rear seat on a buick century?

I had the same question and found this in the online owners manual. http://www.extendedgmwarranty.com/owners-manual/buick/2001-Buick-Century.pdf


Where is door ajar switch on 2007 Buick lacrosse?

The door ajar switch on a 2007 Buick LaCrosse is typically located in the door latch mechanism within each door. When the door is closed, the switch is pressed down, completing the circuit to indicate that the door is closed. If the switch is malfunctioning, it may falsely indicate that a door is open. You can access it by removing the door panel for inspection or replacement.


Why does your break in a Buick park avenue go all the way down?

You are probably losing both brake fluid and pressure through either a wheel cylinder or the Master cylinder . You will need to have a trained mechanic look at why you are having the loss of a brake pedal .


What card do you bow down to?

The master card.