0
What else can I help you with?
How do you replace the pulley to the fan clutch on a 2002 Chevy Trailblazer?
if you do not have no experience in fixing car, do not do it
How to remove fan clutch on the 2007 Chevy trailblazer?
To remove the fan clutch on a 2007 Chevy Trailblazer, first, ensure the engine is cool and disconnect the battery. Use a wrench to hold the water pump pulley in place while you turn the fan clutch counterclockwise to loosen it. Once loose, carefully lift the fan and clutch assembly out of the engine bay. Be cautious of any coolant that may spill during the process.
What clutch do you use for lawn mower racing?
get a smaller pulley for the engine. as far as clutch I'm not sure
What the constatnt loud noise is in my 2004 trailblazer it gets louder when you rev it its not the tens pulley or the idler pulley?
It could be the clutch fan that is going bad. I had the same issue & the expense of the part and manpower can be $400 to $700.
Where is the tension pulley on 1995 ford windstar?
Will be the only pulley that is spring loaded and not connected to an engine component
How does a a lawn tractor drive pulley work?
A lawn tractor drive pulley is connected to the engine crankshaft and transfers power to the transmission. As the engine rotates, the drive pulley spins and drives the belts that are connected to the transmission, allowing the lawn tractor to move forward or backward. By adjusting the position of the drive pulley on the engine shaft, the speed and direction of the lawn tractor can be controlled.
Where is the alternator in a 1994 Toyota 4Runner?
Open your hood and look at the front of your engine. There is a pulley connected to your power steering pump on the right side of your engine. It has hoses coming out of it. If you look below it your alternator should be there. It has a smaller pulley connected to it.
Belt changing belt on trailblazer?
You can change the serpentine belt on your Chevrolet trailblazer, by loosening the tensioner pulley. With the loosened tensioner pulley the belt will come off easily. Tighten the new belt with the tensioner pulley.
What is a tensioner on a Chevy Trailblazer?
The tensioner is the arm on the passenger side of the engine near the front that has a pulley on the end and controls the tension of the serpentine belt. www.trailvoy.com
How do you loosen a trailblazer drive belt tensioner?
The easiest way to loosen the tensioner is to use an automatic belt tensioner. This can be used on a serpentine belt which is connected to every pulley on the engine.belt.
What would cause a 1998 Plymouth Breeze to stall when you turn the AC on?
It could be the AC compressor. With the engine and key off, try turning the compressor by hand. The belt should be connected to a pulley that drives the clutch. With the engine off the cluth is disengaged so you should be able to turn the inner part of the compressor pulley even though the outer part is connected to the belt. If it won't turn at all, it's probably siezed and you need a new compressor.
How do you remove pulley and clutch off on a lx277?
To remove the pulley and clutch from a John Deere LX277, first, disconnect the battery to ensure safety. Then, remove the mower deck and any covers that may obstruct access to the clutch assembly. Use a suitable socket or wrench to unbolt the clutch from the engine, and then carefully pull it off the shaft. Finally, if the pulley is separate, remove it by loosening any retaining bolts or using a puller if necessary.
