0
What else can I help you with?
How much labor to change knock sensor?
how much does it cost for labor to change a knock sensor in a 2002 toyota siennna van
Diagnosing engine knock in 97 astro van?
check the anti knock sensor on the side of the motor
Where is the anti knock sensor on a Chevy 350 block?
It is in front of the starter on my van.1990 350
Where is the knock sensor located in Nissan Quest 2000 and how to renplece it?
dont bother every nissan i have scanned the first code is knock sensor. most people use 87 octane fuel and this will ping once in a while under load when hot new sensor will do the same just clear code. ps under the intake manifold. if the van has a shaky idle yet runs fine when you step on the peddle this model is famous for clogged fuel injectors a professional injector cleaning machine works wonders for smooth idle fuel eco and power
Where is the knock sensor located on 2002 Chevy astro van?
On a 2002 Chevy Astro van, the knock sensor is located on the engine block, typically on the passenger side. It is situated near the oil filter, mounted directly to the engine. You may need to remove certain components, such as the intake manifold or air cleaner assembly, for easier access to the sensor.
Where is knock sensor of gm savana van 2004 5.3L?
the knock sensors (there are 2 of them) are located under the intake manifold on the 5.3 engine,,,,,requires complete removal of manifold to replace.
Where is the knock sensor on a 95 g-20 van?
The knock sensor is located on the bottom of the block just above the oil pan rail. It is either on the driver or passenger side depending on motor size, and is about 1/2 way from the front of the block.
95 Villager is stalling on the go but when restarted goes good for some time Code says knock sensor 34 Is it really a knock sensor problem How do you change it Where exactly is it located?
Also you can remove the front oxgyen sensor and drive it. If the problem goes away it is probably your catalytic converter. The dealer replaced mine because the van has less than 80000 miles on it.I have a 2000 and I tried to get around replacing the knock sensor. I replaced fuel injectors, wires, plugs, distributor and some other parts. All this helped, but van still lose power and surges after engine hot. I been told after all this that the knock sensor retards timing and causes the fuel not to burn as it should. It not only senses knock, but is a protective device for the engine. I just purchased one on eBay for $65 and will install later this week. Should have replaced it when I first got the code.AnswerThat does not sound like a knock sensor problem. the knock sensor senses "knocks" in the engine and retards the timing accordingly. The knock sensor should not affect stalling, the problems are probably not related. The knock sensor itself is located under the lower manifold. It is a lot of fun to get to.
Where do you find the IAT sensor on 1997 Chevy 2500 van?
it will be in the throttle body iat stands for idle air control and its actually not a sensor its an electro magnet that controls what its named for good luck
What is causing your 1995 astro van to idle very high?
try your tps sensor . means throttle position . may be giving a false reading. /
What would cause a 1999 astro van to idle and run rough and the check engine light comes on?
either cam shaft sensor or crankshaft sensor or air flow meter are the common 3 things
Where the knock senor located on a 87 Chevy custom van 305?
it is on the drivers side of engine block screwed into block near side freeze plugs it is a 2 inch round sensor with a wire on top center of sensor
