For a 2004 Jeep Rubicon, the tail light wiring schematic typically involves several key wires: the ground wire (usually black), the tail light power wire (often brown), the brake light wire (usually red), and the turn signal wires (typically yellow for the left and green for the right). To access the wiring, you'll need to remove the tail light assembly, which usually involves unscrewing a few bolts. Always refer to a service manual or wiring diagram specific to your model for precise color codes and connections. Be sure to check for any fuses as well if you're experiencing issues.
Check wiring harness under vehicle and under left rear tailights
Rubicon - 2004 was released on: USA: 2004
A 2004 Jeep Wrangler Rubicon has a 4.0L inline six.
The 2004 Jeep Wrangler Rubicon has the standard 5 on 4.5" Bolt Circle
where can i find a schematic for a 700 polaris atv
2000LBS
No, V-6 was introduced in 2007, the 2004 Rubicon would have a 4.0 Liter I-6 (Straight Six Cylinder) Hope this helps.
Dana
I have a rubicon 2004 the oil capacity is 5.2 to 5.5 quarts. You have to put 5 quarts in and crank the 4 wheeler and let it run for 1 minute and check the oil as soon as you turn the engine off to see if you need to add .2 or .5 to your rubicon. The ? is about a Honda Rubicon ATV.
Check stop light switch for misadjustment or defect
6.5"
10w30