Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specific cause/defect which is causing your problem.
The following generic answer applies to any electrical circuit, whether in a vehicle or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which can cause extreme flow of electrical current [measured in Amperes], and overheating of the conductors that can result in damage to the insulation and the conductors. And in a worst case, the probability of a FIREwhich could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice and install a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
Drivers side under the dash on left . The fuse is 25A
#42, 25A
It's a 25A fuse, Ive been to my local Autozone and all they have is a 25A but it's not for the car, the prongs on the 25A stock GM one are small bronze, and very close together, ive been looking for one for a while now and there hard to find.
No, you should not replace a 20A fuse with a 25A fuse. Fuses are designed to protect circuits by breaking the connection when the current exceeds a certain level; using a higher-rated fuse can result in overheating and potentially cause fires or damage to the wiring and connected devices. Always replace fuses with the same rating to ensure safety and proper functionality.
I had the same problem. I started trouble shooting the system (Fortunitly I have a factory service manual). I diconected the steering column connector and examined the pins . plugged it back together and hasn,t been a problem since ...... except I found I had to put a larger fuse in like a 25a ? BOB
A 25A Circuit Breaker, Dealers Part.
F1 is a 25A fuse and it is listed as audio F8 is a 5A fuse listed for the Radio F20 is a 5A Fuse listed as audio
25Amp Circuit Breakers are mainly used for power window supplies.
NOT a good idea!!!Fuses are sized to handle the load capacity of the wires in the wiring harness and to handle the normal load of the components being driven.Any attempt to run too much current through a wire (such as putting in an oversized fuse) can result in burned electrical components and fire.Rather than overload the vehicle wiring, find out WHYit's blowing the fuse.
i was able to do this by going to the fuse box under the bonnet and removing the power windows fuse, 25A 32v
Yes, there is a fuse for it inside the vehicles fuse panel. However, it is linked to the electronic ignition and taking it out will cause unfavorable results. It is a 25a yellow fuse on the bottom right of panel.
trace the wire and look for a short