First you have to release the hood, the release nob is on the left hand side on the side panel, just left of your left knee.Second you open the hood by pulling the lever on the right side of the the front crest .
Why did my Mercedes Benz s350 key is no working again
To replace the trunk latch on a Mercedes C230, first, open the trunk and remove any trim panels to access the latch mechanism. Disconnect the wiring harness and unbolt the latch from its mounting points. Install the new latch by reversing the process, securing it with bolts, and reconnecting the wiring harness. Finally, reattach any trim panels and test the latch to ensure it functions properly.
How to open gass latch
ARE you wonderig wear the lever is that you pull, or where the hood latches?
To open the bonnet on a 2011 Mercedes CLS 350, first ensure the vehicle is parked and the engine is off. Inside the cabin, locate the bonnet release lever, typically situated on the driver's side near the footwell. Pull the lever to release the initial latch, then move to the front of the vehicle, where you can find a secondary latch under the centre of the bonnet. Lift the bonnet to access the engine compartment.
release the hood near the parking brake then above the grill on both left and right sides is the latch
To open the hood on a 1976 Mercedes 450SL, first locate the hood release lever inside the car, typically found on the driver’s side near the footwell. Pull the lever to release the hood latch. Then, go to the front of the car, slide your hand under the center of the hood, and find the secondary latch. Push the latch to the side while lifting the hood to fully open it.
If you remove the grill from the front of the truck you can then access the safety latch and hood release. My latch had rusted so I had to do this using a flat head screw driver and lifting the safety latch which allowed for the hood release to open.
The 1985 Mercedes 380 SE has a gas door release latch located on the driver's side floor board near the hood release lever. If the gas door release latch is no longer operable, the cable to the door might be broken.
To release the hood of a 1973 Mercedes 450SL, first, locate the hood release lever inside the vehicle, which is typically found near the driver's side footwell. Pull the lever to unlock the hood. Next, move to the front of the car and find the secondary hood release latch, usually located at the center of the grille. Push or lift this latch to fully open the hood.
To open the hood of a 2007 Mercedes-Benz CL550, first locate the hood release lever inside the vehicle, which is typically found on the driver's side, near the door. Pull the lever to release the initial latch. Then, move to the front of the car, slide your fingers under the center of the hood, and locate the secondary latch. Push the latch to the side while lifting the hood to fully open it.