Replace the ECU.
located in the distributor itself, follow wires coming from coil to distributor
You just have to see where it is leaking. There are numberous gaskets and hoses it can be coming from. Have it preasurized and it will be easier to find.
I would try an engine flush to clean the hydraulic lifters. Follow the directions on the can.
check the ignition coil make sure theres power going to it ,and coming out of it. check the ground conection.
Have you checked the ECM relay? it controls everything and nothing will work without it
Yes, it should be located towards the back of the block, and can be identified by the ignition wires coming off of the distributor cap.
If you have spark at all but one plug, the problem is with that plug, wire, cap or rotor.
It sounds like your hearter core. I just had mine replaced. Big Bucks
Check the hot wire coming from the distributor and coil to make sure it is not going to ground
this question best served in the automotive section
there is a gasket that goes under the distriburator that needs replaced.
On top of the distributor. The thing with all the plug wires coming out of it.
located in the distributor itself, follow wires coming from coil to distributor
counterclockwise
No, unfortunately she is Not. No, unfortunately she is Not.
You just have to see where it is leaking. There are numberous gaskets and hoses it can be coming from. Have it preasurized and it will be easier to find.
there already here and they're coming for you