At this point it's just a matter of diagnostics. You need to find an electrical diagram of the vehicle and go back, point by point, testing where you get starter signal and where you don't.
Pay attention to the wiring on the starter. Many starters have a post that's not used on some electronic ignition systems so you should verify that you have connected your solenoid wire to the right post.
Try a jumper from the battery wire directly to the solenoid to see if the starter will engage. If the starter tested good it should engage when you jumper to the solenoid.
Next, go back one step at a time. If you're not getting starter signal from the neutral switch it might just be misaligned.
Next, go back to the keyswitch. If you're not getting starter signal from the keyswitch you might just need to replace it.
Break the problem down into smaller pieces, testing each component individually.
Good luck and let us know what you find.
what can be wrong when 98 Chevy lumina over heats but radiator is new? please help? first off disconnect the battery and then the wires to the silinoid switch on the top of the starter.remember where the smaller ones go. 6 or 8 cylinder the starter is on the pass side and you will have to acess it from underneath.2 9/16th head bolts i think
starter is bad Gen-R
please answer my question. Ford truck 1999 V8 4.6 L does not start of park but in neutral sometimes Why.
u need to replace the starter solenoid
Battery, battery cable or connections, starter problem, ignition switch not working. Be more specific please.
Rephrase please.
Loose or corroded battery cable? Bad starter solenoid? Bad neutral safety switch?
Almost neutral. Please see the link.
I have Lumina car and protested that the battery replaced.Now the radio wants code please help.model.92075550serial no 334000493.5.sameer_alal@yahoo.com
what can be wrong when 98 Chevy lumina over heats but radiator is new? please help? first off disconnect the battery and then the wires to the silinoid switch on the top of the starter.remember where the smaller ones go. 6 or 8 cylinder the starter is on the pass side and you will have to acess it from underneath.2 9/16th head bolts i think
Make sure battery is fully charged Check battery cables --make sure they are tight and not corroded Depending on age and mileage of vehicle--timing chain may have "jumped' Check starter for excessive current draw Check starter solenoid Check neutral safety or clutch safety switches
i have toyota tercel i ned change the starter help please
hows the starter
please answer me with some example
If the 1990 Chevy Lumina is blowing the DIS 10 Amp fuse when the ignition is on, check to make sure that all wires coming from this fuse are grounded properly. Also check to make sure the starter is wired properly. There could also be a loose wire in the dash near the ignition.
Please let me know how to remove the 1979 z28 starter.
starter is bad Gen-R