0
Brake pads are grinding 2 days after replacing pads when coming to a stop it shakes the entire vehicle then sticks when accelerating?
Sounds like the caliber is sticking. I recommend you replace the front calibers and replace the brake fluid with fresh fluid from an unopened can. The shaking probably means the rotors are warped. Replace the rotors and brake pads along with the calipers on your front brakes you should be fine. I would suspect that your brake fluid has become contaminated with moisture. This moisture will cause the calibers to rust and stick. Make sure you tighten the lug nuts to the torc specifications recommended for your vehicle. Over tightening the Lugnuts will warp the rotors.
ANS 2 - If I had that happening 2 days after a change, I'd be looking very seriously about something being done wrongly. Possibly the pads are not fitted properly or are the wrong pattern.
What else can I help you with?
Why is my 1992 auto Chevy Cavalier when i am accelerating to dog down it also acts like it is about to stall out and has dark grey to black smoke coming from the exhaust what is going on?
Oxygen sensor
What could cause smoke coming from the Radiator Fan?
If the smoke is coming from the electric fan itself, then it needs replacing. It could be the smoke is steam that the fan is drawing from the radiator, and you have a coolant leak at the radiator.
How do you fix a rattling or chattering sound coming from the engine on a 1993 Ford Explorer Sport when going up hills or accelerating rapidly?
U do that by fixing the EGR Valve OR the Vaccume hose going 2 it.
How do you know what is making a grinding or scrapping or whining metal noise inside the motor of a 1990 Honda Civic 3dr 1.6l?
It is probably not coming from inside the motor. What you probably have is a bad alternator bearing, steering pump bearing, etc.
Why does the 1996 Chevy Tahoe makes a rattling noise when accelerating cant tell if it is coming from the rear end or the front any ideas?
check the exhaust line one of the heat shield (metal plate between the pipe and the cab) migth be loose
What is grinding crunchin sound when turning my mercury marquis in either direction?
If you vehicle is front-wheel drive, more than likely, that grinding crunching sound when you turn is coming from the CV joints.
Grinding sound in a 1996 Bonneville?
depends on where the grinding id coming from
Noice coming from car when accelerating?
noise and jolting is present whilst car is idolling and accelerating
What is the grinding noise on a megane 2?
It depends on where the grinding noise is coming from. Most of the time the grinding is coming from the brakes and the brake pads need to be replaced. If they've been grinding for a while, the rotors will need to be resurfaced or replaced. Other possibilities for grinding are worn axle bearings, or a problem with the clutch. If the clutch goes out, there will be a grinding noise when you try to shift gears.
Why is your car not accelerating and super thick white smoke is coming from the tailpipe and does not quit smoking?
The head gasket on your vehicle is blown, please see a mechanic as soon as possible. The smoke is quite polluting.
How can I address the grinding noise coming from the front wheel of my vehicle?
To address the grinding noise from the front wheel of your vehicle, you should first check the brake pads and rotors for wear and damage. If they appear worn or damaged, they may need to be replaced. Additionally, inspect the wheel bearings for any signs of wear or looseness. It is recommended to have a professional mechanic diagnose and repair the issue to ensure proper and safe functioning of your vehicle.
A grinding noise heard after replacing brake pads and caliper?
Chances are one of the pads was not mounted properly, causing it to slip out of place and grind against the rotor. Remove the tire in which the grinding is coming from. Check pad placement. If they are indeed aligned properly, maybe try having your rotors machined. Hope this helps. ~Trina~
What are the common signs and symptoms of a tension pulley problem in a vehicle?
Common signs and symptoms of a tension pulley problem in a vehicle include squeaking or grinding noises coming from the engine, visible wear or damage on the pulley itself, and difficulty steering or operating the vehicle. It is important to address these issues promptly to prevent further damage to the vehicle's engine.
Is a car accelerating when it is coming to a stop at a light?
No, when anything is slowing down it is decelerating.
What could cause a grinding noise coming from underneath the car on the driver side?
wheel bearings, worn brake pads, dry u-joints could be one of many sound travels on a vehicle but start with those
Why does your car make a loud clicking noise while in motion but not accelerating?
Clicking sounds coming from the vehicle may indicate there are loose valves. Aside from getting a mechanic checkup, adding high mileage motor oil can also be helpful.
96 Jeep Cherokee 150K. Would the Mass air flow sensor or oxygen sensor cause black smoke when accelerating poor gas mileage and the vehicle to almost lose power when coming to a stop?
Check your air filter
