Cement Plastered Walls can be made smooth using Wall putty and Paint consumption will be less when wall putty is used.
Putty should not be allowed to dry completely. If it does, then it will become brittle and may shrink and crack. The main purpose of putty is to form a seal between the glass and the wooden window frame. The putty should be painted to seal in the linseed oil which keeps it pliable. A film of hard putty on the surface forms after 2 to 3 weeks (weather dependent) and then the painting should be carried out to stop any further drying of the putty.
I think it might roll off. Kind of like a mercury effect. Does silly putty consist of some sort of rubber or oil substance? with my research silly putty gets harder when put in a cup of water .
you can soak it in vinegar or you could bake them in the oven and bake them for no longer than 30 min.
The word bake is a verb (bake, bakes, baking, baked) and a noun (bake, bakes). Examples: Verb: We're going to bake some clams. Noun: Are you coming to the clam bake?
No. Use the putty.
You can use silicone as a substitute, but plumbers putty is simpler and far easier to clean up. 100% SILICONE
Oils from putty soak into and discolor marble. Putty not used when putting pipe together.
Put putty under outer edge of faucet base and fasten to sink. Remove excess putty after fastening faucet.
If it is real marble, the oil in the putty can leach into the marble and discolor it.
pipes plunger putty
Search for granite poltice online. For more info go to solidsurfacealliance.org or forum.solidsurfacealliance.org
You can purchase plumbers putty and teflon tape at any local hardware store. These items are also available at large chain home improvement stores such as home depot or lowes.
It will not dry out and if the drain needs to be removed at some point, it can be. Glue would make it difficult to work on. Modern 100% silicone caulk will also work, and can be removed easily, like plumber's putty.
I think mainly to make it more malleable from the warming effect. It also makes it more consistent if it has dried around the edges
It sounds like you are installing a new faucet. If that is the case read the manufacturer's instructions. If you are re-installing an older faucet, using the plumbers putty doesn't hurt.
Get a candle and use it to heat your putty knife. It will slice though the old putty like butter. Just keep reheating the knife. The best way to soften plumber's putty is to add a little linseed oil and allow it to sit overnight. Knead the putty thoroughly. This won't do if you're in a hurry, so you could try to hurry it along by kneading it with a very small amount of linseed oil (use gloves). Remember to keep the consistency a little bit thicker than Play Doh.