sure you can, you just need to get a 4 bbl. intake manifold for the 318-340 engine, edelbrock makes them and summit racing or jegs sells them.
fuel pump is the first place i would look
you have to turn key to position 2, there is a hole on the side of the casing the barrel slides into facing upwards. Press small Alan key into hole and press a button down and barrel should slide out.
try a parts store and see if they can order you one., other than that you will have to try an after market place.
Put them in place on the windshield where they should be and then press the arms onto the splines on the posts sticking out of the cowl panel.
It sure seems like fuel would be a good place to start.
Starting point is to check for fuel at the carburetor and spark at the plugs. Whichever one is not there will give you a place to start backtracking to find the problem
no efi stands for electronic fuel injection which takes the place of a carburetor
It's called a primer bulb, ebay is a good place to start looking. :)
the carburetor or the fuel pump this takes place in the intake manifold
Your local Dodge dealer would be a good place to start...
A barrel clamp is a device used to secure a barrel to a structure or another object. It typically consists of bands or clamps that can be tightened around the barrel to hold it in place. Barrel clamps are commonly used in industrial settings for transporting or storing barrels.
Need picture of carburetor vacuum connections and what they connect to
A dodge dealership is a great place to get a dodge vehicle fixed, as they know the cars and trucks better than any other repair shop. You can be sure you are getting the right parts for your vehicle at a dealership.
Depends on the size of the barrel. An oil barrel holds 42 gallons. But a 55 gallon barrel holds 55 gallons. Gasoline is not stored in barrels in the first place, it is stored in tanks which vary in size.
On fuel injected vehicles like your Honda the throttlebody would replace a carb
Your carburetor is loading up. Or your needle valve is out of place or stuck.
when there is icing on your carberator to clear it off, or to prevent it from building up in the first place