You should check the label on the specific product you're planning to use. If the label states it will adhere to wood with an existing coating, then it's fine to use even over an oil-based stain. (This is because once thoroughly dried, oil-based stains behave the same as water-based stains.) Some products, however, will require the existing stain to be stripped from the wood, or to apply a primer coat over the existing finish before applying new stain.
you need to wipe the excess stain off the deck with a clean rag. It will never dry and it will float to the top of the sealer
CAN you? Yes, however you shouldn't unless it is well shielded from the sun's UV rays otherwise, it will quickly fade. Also, most interior stain has no mildewcides added so you'd need to apply an exterior clear over the top to slow mildew growth.
As long as acrylic is solid and not flaky you can.
Yes, but only if the stain is a few years old and really dry. You have to wash the stain thoroughly to remove the chalked pigments and then prime it to seal the checks in the wood. One disadvantage of stain is that it will not keep the wood from checking as it dries. Either a latex of alkyd primer will work well. You can then paint it with your latex top coat.
No you can not.
you need to wipe the excess stain off the deck with a clean rag. It will never dry and it will float to the top of the sealer
If it is just the stain with no top coat or sealer on it, just wipe it down with a rag and mineral spirits, paint thinner, Lacquer thinner, anything to put the stain back into solution.
Yes you can, just clean the old stain with steel wool or fine sandpaper before you do.
To determine if your deck is dry enough to stain, perform a simple water droplet test. Sprinkle a few drops of water on the deck surface. If the water beads up and sits on top of the wood, the deck is not ready to be stained. If the water is absorbed into the wood within a few minutes, the deck is dry enough to stain.
Some of the top rated deck stains on the market include Behr Premium Semi-Transparent Wood Stain, Cabot Australian Timber Oil, and Thompson's WaterSeal Signature Series. These stains are known for their durability, protection, and overall quality.
Yes, that would work as a painting technique.
To build a pergola on a deck, you will need to first determine the size and location of the pergola. Next, attach support posts to the deck using brackets or anchors. Install crossbeams and rafters on top of the posts to create the roof structure. Finally, add decorative elements and finish with a coat of paint or stain for protection.
CAN you? Yes, however you shouldn't unless it is well shielded from the sun's UV rays otherwise, it will quickly fade. Also, most interior stain has no mildewcides added so you'd need to apply an exterior clear over the top to slow mildew growth.
As long as acrylic is solid and not flaky you can.
If the door has a primer or a paint on it then no. Stain needs open grain to work. Stain seeps into the pores of the wood. If there is a coating, i.e. the primer or paint, then the stain will have nowhere to go. It will just sit on top of the coating until it is wiped off or dries in ugly blotches.
yes..paint KILZ on first Or paint any oil based primer first if your topcoat is water based. Kilz is a stain kill primer and even though it dries fast, it tends to be hard to sand. An enamel undercoat works much better as a bridge. If you're using an oil-based top coat, you do not need a primer, just make sure that the surface is clean and gloss free.
Yes, you can paint on top of spray paint with other types of paint, such as acrylic or oil-based paints.