look in the trunk. if it has the relay button, it would prolly be on one of the sides, usually in a compartment. it would be a red button if im right. hope i helped
It is located in the trunk.
It's a latching push button switch. To operate this type of switch, you press the button, which then latches into place. To switch off, you press the button again, which returns to its home position. Just like the power switch on your TV or HI FI.
You need to adjust your brake light switch. It should be located on the brake pedal. Unplug the switch and loosen the nuts to adjust the button closer to the brake pedal.
You are probably referring to the inertia switch. In the event of an impact there is a switch that will disable the fuel pump on most Ford vehicles. Often times this switch is triggered by accident even if the vehicle was not in a collision. It is usually located under the right kick panel on the passenger side. There is a button that pops up on the top when the switch is triggered. To reset you simply press the button back down. See your owner's manual for details.
when you start the car up that's your ignition switch is located...
Does not have one.
You can find the starter relay switch in your 2000 Mitsubishi Eclipse in the fuse box. The starter relay switch will be in the third column, at the top.
It is located in the trunk.
does a 2004 mitsubishi eclipse had a fuel shut off switch
The fuel pump cut-off switch, also known as the inertia switch, on a 2009 Mitsubishi Eclipse is typically located in the trunk area, near the fuel pump or on the rear wall of the trunk behind a cover. It may also be found under the driver's side dashboard. To reset the switch, you may need to press a button or switch that is visible on the unit. Always consult the owner's manual for specific details related to your vehicle.
If you are looking for the cooling fan switch it is located just to the left of the lower radiator hose, screwed in to the lower tank.
Why will my 2000 mitsubishi eclipse gs not change gears? its like its stuck in 2nd or 3rd? i have no clue whats wronmg with it
It does not have a reset switch.It does not have a reset switch.
I might be wrong, but I think the "kill switch" is a part of ECU.
the window switch is bad
The fuel inertia switch on a 1993 Mitsubishi Eclipse is typically located in the passenger side footwell, near the kick panel. It may be mounted on the side of the dashboard or near the fuse box. To access it, you might need to remove a cover or trim panel. Always refer to the vehicle’s service manual for specific instructions and locations.
Hold the temp button down until the degree sign flashes then push the temp. button again to switch from Fahrenheit to Celsius.