The amperage is printed on the ballast. If your meter reads higher that that what is printed there, then the ballast is drawing more amps that it should.
You just have to divide the watts by the voltage to find the amps. For example 60 watts on a 120 v system would take ½ amp.
Computers are not as intelegent as us humans because it's us humans putting the information into them. Yes, it is possible to find fluorescent colours on paint, although you need awesome acuracy and colour skills to find them. Think of a yellow highlighter for example, and what the colour is like.
To locate the dash lights fuse on a 1999 Honda Accord to find out if it is causing the dash lights do not work when you have the parking lights on after installing an after-market radio, check the owner's manual. You can also find a fuse diagram at most auto part stores.
Yes. It depends on the fixture. If the bulb runs at line voltage (i.e. without a transformer), then yes. If it's a low voltage halogen bulb, such as a 12 volt running off of a transformer, then you'll need to find out if the transformer is dimmable.
You find it in mosques on prayer rugs, on doors, ceiling's, walls, and sometimes lights!
fluorescent lights
You can find it in fluorescent lights, batteries and some thermometers.
School Office Hospital Store Bathroom Factory Diner
There are special contactor that are made to switch lighting loads. These relays and not wattage rated but amperage rated. Use the following formula with the voltage that you are going to use to find the size of contactor that you need. I = W/E, Amps = Watts/Volts.
Wire size is based on the amperage drawn. To find the amperage, the voltage must be stated. Use this formula to find the amperage. I = W/E. Amps = Watts/ Volts. Once you have the amperage, restate your question using the new found amperage or state the voltage that supplies the lights.
By using a Multitester.
Multiply the vots by the amps to find the volt-amps. Or divide the volt-amps by the voltage to find the amps.
Ohms can be found by using these formulas. Ohms = Volts/Amps, Ohms = (Volts (squared))/Watts, Ohms = Watts/(Amps (squared)).
Volts x Amps = Watts
You cannot be allergic to fluorescent lights. Some people, however, do find them irritating due to their sound and light quality. It is also possible that a person's emotional reaction to the qualities of fluorescent lighting can cause them to experience physical symptoms due to an increased production of various neuropeptides.
It can be interferance caused by Fluorescent lights, Transformers, (such as battery chargers) switchless lights, you name it. Anything that plugs into electric current in your home can in one form or another. In your quest to find the problem, you will often overlook what the actual problem is.
You can find information on fluorescent bulbs all over the internet. You can also check packages of the bulbs at department stores or grocery stores where they are sold.