If your vehicle happens to be a Chevrolet or GMC, turn the ignition to the on position and push the gas pedal to the floor three times within 5 seconds, the oil change light should flash five times and you're done.
Turn your key to the 2nd position for 30-45 seconds (don't start the car). This should reset it.
take it to the local BMW garage and they'll do it
take it to the local BMW garage and they'll do it
The thermostat on a 1987 BMW 325i can be found by following the upper radiator hose. The thermostat will be located on the side of the engine.
Maybe your steering wheel it's keeping the ignition cylinder to turn, so move the steering wheel and at the same time try to turn the key. Maybe you need to replace the ignition cylinder key lock
If it is just the headlight you buy oem part or H7 light bulb or bulbs, right or left, whichever. Lift hood, check area which one you want to replace,and make sure you do this during daylight or if you have a nice and powerfull flashlight that ok too. Each gray housing of the H7 bulb has a specialized locking mechanism and it only open one way, click it or wiggle it just a little, and it should loosen. Pull it away from the headlight assembly, and that's should be it. Just loosen the bulb by upward motion. That's it.
AnswerIt may sound silly, but the best option is the dealership. I've seen many manuals for BMW but the manuals at the dealership are the best. Sometimes they are cool and they will let you borrow them, photo copy or let you get just the info you need to write it down. Others will tell you that you just have to buy it.Look into buying your own Bentley (the brand name, not the car manufacturer) manual. I bought my own for my E36 and it becomes your Holy Grail. www.bavauto.com is where I get all of my stuff. You can also call them if you ever get stuck with a tough problem.
The starter motor is located on the back side of the engine (closest to the firewall) underneath the fuel injection/intake manifold. If you are going to replace it, first disconnect the battery, then remove the main power cable (heavy wire) and the start wire (light wire). Next remove the two bolts for the intake manifold support bracket and remove bracket. Remove one bolt on starter rear support bracket and 3 bellhousing flange blots (two accessible from starter side, on accessible from bellhousing side. Good luck Malcolm
Reset inspection light on 1989 bmw 325i
reset service engine light on BMW 325
you may need to replace the sensor for the coolant, there should be a wire connected to it.
You need a scan tool to plug into OBD port
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
Check out the realted link for some advice on how to reset the computer in your 2003 BMW 325I computer.
The oil pressure sensor on a 2004 BMW 325i is located on the bottom, right side of the engine. It is screwed into the block and has an output wire which sends information to the computer.
The brake warning light on a 2005 BMW 325i can be reset by connecting an OBD II code reader. It can view and clear error codes detected by the computer.
Have vehicle scanned to determine the problem (usually in the emission control system) and have codes cleared
this is a German car, there is no "reset" button,
many service lights on the new 3 series you cannot reset yourself, this is a software error by BMW and they are aware of this but currently no fix is available, the only way to reset it is to have a BMW technician reset it with their special service equipment.
depneding on model/yr, either thru console mounted button, or thru turn signal stalk