answersLogoWhite

0

A puller/installer tool can be purchased from NAPA that removes and installes the pullies on all pwer steering pumps. It is made by KD tools and comes in a handy little red box with instructions.

User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Art & Architecture

How do you replace the engine air filter in a 2006 sts cadillac?

Open hood. Remove plastic housing securing air filter. Install new filter. Replace what you have removed. Your finished!


How does one take offf a steering wheel on a 1982 Chevrolet TK model PK body style 12 ton with a 305 small block engine?

You will need a puller to remove the steering wheel, after you remove the nut and snap ring in the center of steering wheel. Ther are two holes in the wheel that are threaded. Install puller on center shaft, and screew 2 long bolts through the puller and into the holes on wheel.


How do you replace power steering pump in 1997 lumina?

First you must remove the upper portin of the fan shroud. Remove the belt, take a pully puller and pull the pully off the pump while it is still in place.undo the lines out of the steering sector(remember the high pressure line goes back in the hole closest to the engine block) Remove the three bolts behind the pulley, then remove the two nuts on the bracket behind the pump one is under the manifold and the other is on the bottom of the block. THen take the pump out remove lines and hardware and place on the new pump. WHen installing the new pump, put the pump back in place and the press the pully back on after you have put all the bolts back in the pump.


How do you install a power steering pump in a 1999 mercury tracer?

first thing is you need to pull off the belts, and yes all of then because the stering belt in behind the others. then there is two bolts holding the pump so remove them and then just remove the high and low pressure lines and your done.


How can you remove the left spark plug on a 2001 Chevy s-10 v-6 engine when it is blocked by the steering column?

Move the steering shaft. There is one bolt under the plastic cover. This is the pinch bolt .Remove it and slide shaft towards firewall ,move shaft out of the way ,replace plug,re-install shaft,bolt and plastic cover.

Related Questions

How do you remove dash pad on a 2000 Cadillac el dorado?

You can refer to the service and user manual on how to remove a dash pad on a 2000 Cadillac El Dorado.


How do you remove and replace a steering column in a 95 Cadillac Sedan Deville?

How to remove and replace a steering column on a 95 Cadillac Sedan Deville?


How do you remove door panels on 1983 Cadillac el dorado?

I have a 1983 Cadillac El Dorado and the window on passenger side doesn't work. I checked power to switch (ok) and checked switch and it is also ok. I assume that the wiring is loose or motor is bad. How do I remove panel on door


How do you tighten tilt steering column on 89 Cadillac sedan deville?

How long does it take to remove a steering column on a 1989 Cadillac Deville


How to install Cadillac thermostat?

remove the old one first


Hw do you remove power sterring pump pulley on a 91 Cadillac Seville?

Begin by removing the power steering pump belt from your 1991 Cadillac power steering pump pulley. Remove the power steering pump pulley retaining bolt. The retaining bolt will be in the center of the pulley.


How do you remove the original steering wheel from a 1988 Cadillac?

You need a steering wheel puller. Any Auto Parts store can help you.


How do you change the power steering pump on a 1978 Chevy?

Remove the belt for am your power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.


How do you remove the power steering pump on a '98 Olds Achieva?

Remove the 1998 Oldsmobile power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.


How to replace the power steering pump silhouette?

Remove the belt by loosening the tensioner pulley. Remove the power steering hoses. Remove the retaining nuts. Reverse the process to install the new power steering pump.


How do you change the ignition cylinder on a 1991 Cadillac Eldorado?

Remove steering wheel and signal switch


How do you replace mark viii power steering pump?

Drain the fluid from the power steering pump. Remove the power steering hose. Remove the wiring harness from the power steering pump. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.