0
Thanks for the info. My top doesn't always go down, but of course today when I took it to the dealership it worked. Where do I find the conv. motor? (I've only had the car a couple of months.) 98' Mustang
Not sure if your motor is the same as mine ('71 Cutlass), but mine says the same thing: fill with Type A Transmission Fluid. Mine has a rubber plug on one end of the motor. All I have to do is pull that out (carefully so as not to tear it) and funnel in the fluid. After you fill it (until it runs out the hole) I would recommend running the top up and down a few times, then refill it. This should bleed out any air in the hydraulic lines. It's that easy for me...hopefully yours is the same. Oh, and I believe that Type A transmission fluid is equivalent to today's Dexron III or MERCON. Good luck!
Filling the reservoir until fluid runs out is a disaster waiting to happen. The reservoir should be filled with the convertible top in the lowered position and the final level should be approximately 1/4 inch below the bottom of the fill hole. Here's why: The reservoir is a buffer. There is always fluid in the upper and lower portions of the lift cylinders. When the cylinder rod is fully retracted, the reservoir is at it's highest level. This is due to the cylinder rod displacing some of the fluid in the cylinder. When the rod is extended (top raised) the entire bottom of the cylinder fills and reservoir level wiil be at it's lowest point. Imagine what happens if you fill the reservoir while in this position, and especially if you fill it until fluid leaks out. Hmmm, lower the top, level rises until there is no more room in the reservoir (or air volume is compressed until pressure blows the oring seals out). At this point, pressure in the reservoir will be greater than 300psi. (these pumps dead head at about 300-350psi) This means the main oring seal will blow out and the fluid in the reservoir will now be in your trunk. No one wants that.
What else can I help you with?
I have a 2000 Sebring convertible. The top goes down fine but won't come back up past a few inches. I can hear the motor running. Thanks.?
From what i have been told and read that means the pumb needs hydraulic fluid , it might have a leak in one of the lines.
Location of convertible top bypass switch for a 99 Mitsubishi eclipse?
It is located in the trunk.
Can the top not going up mean it needs hydraulic fluid IN A 2000 CHRYSLER SEBRING CONVERTIABLE?
it can if it is hydraulic it may be an electric motor that works same way as window winder
My convertible top is leaking water like a coffee filter why?
you have obviously washed or cleaned the top with wrong cleaners. you need to completely dry the top and have it waterproffed again. if the top is canvas,instead of vinal, it is was that waterproofs canvas
How much does it cost to replace a convertible top?
It's too hard for a regular person. Buy an upholstery book, or let an expert do this one.the convertible top itself costs about $300.00 but to get it put on it costs about $500.00 in labor fees. so all together it cost $800.00 about give or take
Can you add power steering fluid to your convertible top motor?
GM uses different fluid on hard top convertible!
How do you add hydraulic fluid to Porsche convertible top motor?
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
How do you add fluid to a 2005 PT Cruiser convertible top motor?
Check
What type of hydraulic fluid is specified for a 1997 Chrysler Sebring convertible?
The convertible top motor uses automatic transmission fluid.The convertible top motor uses automatic transmission fluid.
How do you add fluid to a convertible top on a 2004 SL500?
no
How do you add fluid to Chrysler convertible top?
by beaning stupid \
What kind of fluid do you put in a 1992 lebaron convertible top motor?
Automatic transmission fluid.
How do you fill the fluid to work there convertible motor for a 1965 coronet?
To fill the fluid for the convertible top motor on a 1965 Dodge Coronet, first, locate the hydraulic reservoir, which is typically near the motor itself in the trunk area. Use a funnel to add hydraulic fluid specifically designed for convertible tops, ensuring you don't overfill. After filling, operate the top several times to circulate the fluid and check for any leaks. Always refer to the vehicle's manual for specific fluid types and capacities.
How do you put fluid in convertible top motor?
To add fluid to a convertible top motor, first, locate the motor, which is typically found near the rear of the vehicle. Check the owner's manual for specific instructions, as the process can vary by make and model. Use a funnel to carefully pour the recommended hydraulic fluid into the motor's reservoir until it reaches the appropriate level. Always ensure the correct fluid type is used to prevent damage to the system.
How do you add fluid to a convertible top motor on a 1987 Toyota Celica?
The tank for the top motor fluid is in the trunk under/ near the spare tire. I think it is on the left side. You have to pull back the trunk lining. It takes power steering fluid also dot three brake fluid,
How do you add hydraulic fluid to a vw convertible top?
To add hydraulic fluid to a VW convertible top, first locate the hydraulic fluid reservoir, typically found in the trunk or near the convertible top mechanism. Use a compatible hydraulic fluid, ensuring it meets the manufacturer's specifications. Remove the reservoir cap, add fluid slowly until it reaches the recommended level, and then replace the cap securely. Finally, operate the convertible top a few times to ensure proper fluid distribution and check for any leaks.
What type of fluid is required for a 2004 Chrysler Sebring convertible top motor?
Automatic transmission fluid.
