Wiki User
∙ 8y agoWiki User
∙ 8y agoGo to this website. It will show how to remove the door panel and the side mirror.
Rear end of the engine - front end of the transmission
By the left side do you mean looking at the vehicle? Could be coolant, Power steering fluid, or oil watch levels or check to determine which
If it has the 4.3L or the 2.5L engines it would be located under the hood, on the firewall, drivers side, close to the master cylinder. If it has the 2.8L engine it is located under the hood, on the drivers side inner fender.
If you have the 1.0 3 cyl engine, it takes 4 quarts with an oil filter change also.
The swap will work . You may have to change exhaust pipe, swap the ECM with the one from the 91 engine. You are going to have to look and check the wiring harness in the 96 , You may have to swap the too. Probably be easier just to find a used 2.2L.
No.
twist the mirror inward toward the door and then you will see the mounting screws on each side of the mirror.you can see the line around the mirror where it twists.
There is no code 91. The codes start at 12 and stop at 53.
i recently had to replace the passenger side mirror of my 93 blazer, at first i attempted to fix the white mirror mounts behind the glass, but they wouldn't sit right after some frustration i decided to go to the junk yard and pay $10 for a new power mirror, this is most likely ur best bet
yes it will fit may have diffrent window trim and you will have to use your door panel if it is a front door you will have to change mirror also u will need to change your handle your 91 should be chrome
a 91' or 92' Ford Taurus.
Rear end of the engine - front end of the transmission
If it's the Vulcan engine, it doesn't have one
I have a 91 taurus, and re-did the entire wiper system in it. The Main relay is , under the hood, on the right side of the wiper motor, "looking torwards the windshield." It is a black box with a clip and a wiring harness. It can be a little difacult to remove the clip at times. Good luck.
Afi 91-203
The 1991 Taurus has the old OB1 system. The data connector is at the firewall ( under hood )on the passenger side. It consists of a 6 pin connector and a single pin self test connector. This vehicle can be self tested through the check engine light. You will need a manual for the procedure.
Try looking in the mirror? ha! good one!