my speed sensor on my hardbody was a simple bolt off/bolt on sensor attached to the abs. It took removing the wheel, hub assembly (which needed packing anyways), rotor and calipers to reach it. good luck
If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
1-3-4-2
There isn't a way to disable the governor. The computer takes input from the engine speed and vehicle speed, when it reaches a certain point (actually about 97MPH) the computer shuts off the fuel injectors and ignition at the coil util the speed drops back down.
The low pressure switch will do that when the system is low on freon.
I'd suggest checking the Auto Zone or O'Reillys web sites for current prices.
YES.
it is on driver side of trany on the tail end
on the rear of the transmission it has a single bolt holding it in, and usually has a + symbol on it.
where is mass air sensor on a1995 nissa xe pu trk
go to jtr ( jags that run ) you will find a complete speed sensor download, , don
no 84 and 85 change out.
check if it has a speedometer cable if not the speed sensor needs to be replaced
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.
750
99 mazda b3000 where is the speed sensor located