The PCV is a small black or grey plastic item, which is fitted down into a rubber grommet in the passenger's side valve cover. It will have a large diameter vacuum line attached to it. Replacing it is simple. Pull it out the valve cover, remove it from the line, and install the new one. It's a 1 minute job.
it is beyond the main throttle body. it is round about the size of a tangerine. it is black on my car.
Assuming you mean the egr valve, I would make sure that you have the check engine codes cleared. In addition, are you sure that it was truly the egr valve, and not the DPFE sensor monitoring the valve?
The exact location of the transmission modulator valve on your Ford Mustang is dependent upon the year of the Mustang. Most of the time the transmission modulator valve will be on the back of the transmission.
I just did my 2005 Ford Escape front brakes and the caliper was 7mm Allen and main holder is 18mm ...RRR Wis.'
No. Ford changed the headlamps and front bumper/grille area for the 2005 model year.
How do you replace the EGR Valve on a 2001 Ford Escape?
About one hour.
its on top of the engine,in the back right corner.
Catalytic converter plugged?
The 2002 Ford Escape has 16 valves.
According to the 2002 Ford Escape Owner Guide : With engine oil filter change the 3.0 liter V6 engine takes : ( 5.5 quarts )
where is the fuel reset in ford escape 2002
The 2002 Ford Escape has an inline 4 engine.
The 2002 Ford Escape is a gas-powered vehicle.
The 2002 Ford Escape runs on regular unleaded.
The 2002 Ford Escape's turning circle is 35.4 ft..
The 2002 Ford Escape has a 28.5 degrees angle of approach.