The exact location of the transmission modulator valve on your Ford Mustang is dependent upon the year of the Mustang. Most of the time the transmission modulator valve will be on the back of the transmission.
Your mustang with a manual transmission takes automatic transmission fluid. the capacity is 5.6 Pts (US). The fill plug is located on the side of the transmission. Macs Transmissions 281-394-4951 Macstransmissions@gmail.com
first pull off the line going to it and if it has fluid in it change the modulator. Next, take the modulator off and apply vacuum to the line and stick a screw driver in the end of the modulator and see if the diaphragm moves the valve inside. If the valve doesn't move, replace the modualtor. - i am assuming ford but also you can pull the vac.line off of carb.or wherever it draws the vacume from without getting under car and check for fluid at that point Consider getting yourself a service manual as it contains many troubleshooting for your car. Comes very handy sometimes.
The 3.8 liter V6 engine in a 2000 Ford Mustang has a timing CHAIN
The Ford Bronco transmission can use any SAE certified transmission fluid. Ford transmissions manufactured before 1979 will need an F type transmission fluid.
Transmission Modulator 1996 ford mustang can not find location
If you mean the modulator valve for the transmission its on the side of the transmission. Under the car.New Answerthe 1987 ford crown vic with a AOD overdrive transmission does not have a modulator valve
A modulator valve is located inside the case, in front of the modulator.
On a 1994 Ford Explorer : The modulator valve is on the outside of the A4LD automatic transmission , on the passenger side of the transmission , I believe it is behind a heat shield
On the Ford A4LD automatic transmission the modulator valve is on the passenger side of the transmission ( it might be behind a heat shield )
Starting with the 1995 model of Ford Explorer the automatic transmission was ELECTRONICALLY controlled , so there is no modulator valve
On a 1992 Ford Explorer ( A4LD automatic transmission ) I believe the modulator valve is on the passenger side of the transmission , BEHIND a heat shield
modulator valve on the transmission.
On a 1994 Ford Explorer : The modulator valve for the A4LD automatic transmission is on the passenger side of the transmission ( I believe it is behind a heat shield )
I believe that is on the passenger side of the A4LD transmission behind a heat shield
On your 1989 Ford Ranger : The vacuum modulator valve is on the passenger side of the A4LD automatic transmission ( it might be behind a heat shield )
Transmission Modulator Valve? Location=Right hand side of the transmission close to the rear .Covered by a heat shield because of the heat from the exhaust.Do not lose the pin after removal.Verify replacement modulator .Make sure it's your type.C3 transmission modulator look almost identical.Verify measurements at pin location .