If it's like the '96 Celica, it's actually easy. Once you remove the bottom panelling, the ignition switch sits on the back of the whole ignition lock assembly. Here is a picture of it: http://forums.off-road.com/Toyota-suvs-trucks/174186-ignition-lock-disassembly.html Here is some good pictures of the actual switch http://www.oreillyauto.com/EW3/ProductDetail.do?id=1812614240&line=BWD&itemNumber=CS196&id=1355780635&line=BWD&itemNumber=CS196&id=1078488899&line=BWD&itemNumber=CS196&categoryIndex=2&didSearchFor=Ignition+Switch&vehicle=1996TOYOTACELICAGT4-2164%202.2L%20DOHC&bid=1208719500716&cycleCount=741¤tPage=0 BWD AUTOMOTIVE - Ignition Switch Item No: CS196 Now here is the easy part, push back the duct work, it just pulls apart, unscrew the two screws on the back and it's out....
2002 Audi quattro 1.8 ignition module location
Genuine BMW # 61326901961
turn ignition switch to run do not start press gas pedal to floor three times within five seconds change oil light will flash if you did it rght turn off then start engine then you are done
Ign. switch can be replaced. Remove steering column covers, switch is located on left side of column. The above is correct, but you will have to have the tumblers from your old ignition switch transferred to the new assembly IF they are not worn out. Do do the smart thing purchase the OEM as the aftermarket switch is a tad bit less pricey than the OEM, but why take a chance on an aftermarket item! NO, I do not work for a Chrysler/Dodge dealer!
I have a 2001 celica and it uses a 10watt type E bulb.
ignition switch
To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
Take off the shroud, take off the lower dash panel, unscrew the harness that goes down the column, the ignition switch is held on by two clips push in both of the clips and the switch will slide out.
What is the problem you are having with the switch?
Its where you insert the key
YES.....
The ignition of my 2002 Corolla also gets hot? Any others?
2002 Audi quattro 1.8 ignition module location
i do not know go to a car stereo install ... store
please check out this website: http://www.mr2-tech.com/bgb/mechanical/volume2/brake_system.htm click on " pe36t" this is the same system as your (and my) celica