turn ignition switch to run do not start press gas pedal to floor three times within five seconds change oil light will flash if you did it rght turn off then start engine then you are done
It is on the evaporator case and is held in with 2 screws.
If the light for the gear shift on the console does not work on a 2002 Toyota Camry, it is probably a burned out bulb. The console will need to come off to access the bulb to change it. This part is held onto the console area by screws.
If system was opened to the atmosphere it will have to be evacuated prior to charging
Yes!
When the ABS light is on it is for a reason, a sensor could be bad, or another major problem. The light wont go off until the problem is corrected or until the light burns out
Refer to owners manual
You must have the special needed tool to reset the oil indicator light.
vice & oil reset 2002 sl500
To reset the change oil light in a 2002 Yukon XL, first turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Then turn off the ignition, and when you start the vehicle again, the oil change light should be reset. If it remains on, repeat the process to ensure it resets correctly.
To reset the "CHANGE OIL" light, turn the ignition switch to the "RUN" position with the engine off. Fully depress and release the accelerator pedal three times in five seconds. The light will flash twice and go out.
how do i reset timing belt light on 1hz
Once you have repaired the cause of the light, it will reset itself.Once you have repaired the cause of the light, it will reset itself.
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
It is very easy to reset the check engine light on a 2002 Volkswagen Cabrio. The negative battery cable can be taken off for one minute and replaced to reset the light.
A 2002 Jeep Wrangler does not have a reset switch.
On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink for 5 seconds meaning you have reset the system. If it doesn't blink for you do the procedure again.
To reset the reminder light on a Toyota, you need to turn the ignition key forward without starting the vehicle. You then need to pump the gas peddle 3 times within 10 seconds and it will reset the reminder light.