Check spark timing and plug gap. Service the carburettors.
Bad synchronizer. Internal transmission repair required to fix.
The year, make and model info would be helpful.
It sounds like your VSS(Vehicle Speed Sensor) has gone bad, which will turn on your check engine light.
The resistance of speed sensors is of great importance to the abs system computer in your vehicle. The wires are a part of that overal resistance. It is usally advisable to replace the cables with new ones if they are damaged. However; if one knows what the resistance should be and has an ohm meter one could attempt the fix. Then measure the resistance in that cable from the computer end of it ( disconnect battery first of course ) and make sure it falls within the specs it may work.
How do u fix a misfire
Cleaning the fuel injectors is a good start.
Yes there is... It's call a TUNE-UP...
clean out the MAF sensor with some alcohol
To fix hesitation on a 1998 Subaru Forester, measure the lengths and take a ground from battery to the intake manifold on the driver's side. Then to the passenger side manifold and onto the other strut tower. Finally, ground from battery negative to the fire wall.?æ?æ?æ
First you will have to determine what is wrong with it before you can fix it.
check the vehicle speed sensor buffer located buy the computer look under and behind the glovebox
Where do the shoes go on a 1988 fleetwood brougham
how do fix overspeed problem on genorater
To fix the horn on a 1988 Camaro, check the horn fuse first. Then check the horn relay, wiring, horn, and switch to find the problem.
In the Heat of the Night - 1988 Quick Fix 4-7 was released on: USA: 6 November 1990
To figure out how to fix it, you need to start by figuring out what exactly is wrong with it.
The easiest way to fix a 1988 Ford Bronco gas hose leak is to replace the hose. You can also patch the week in the hose.