it my be that the steering wheel is to far over in order to realese. try pulling down the oppsite way from where the wheels are turned to. ie if the wheels are turned to the left turn the wheel to the right, at the same time try turning the key an remove it .
call your local friendly gm dealer and have your vin ready
electronic ignition
It is important to have a diagram when making electrical changes to a car. A free electrical schematic for this cars ignition switch can be found in the manual, or a person can ask a tech at a shop to print one off.
Turn the ignition key to the on position (do not start the van) and immediately step the gas pedal to the floor 5 X within 5 seconds. Repeat if it does not reset. to check if reset key off and start van lamp should go out within a few seconds.. D. Peterson Auto tech 30 years Master ASE
Yes.
sorry to say, its easier just to get a new egnition
It will not hurt anything to leave the key stuck in the ignition on ACC in a Mazda van for short periods of time. The ACC slot on the ignition allows the driver to use accessories such as the air conditioner and radio without the car being in motion. If the key is left in this position for too long it can run down the battery in the car.
The key is only available from the dealer.
To remove the "key" ignition, insert a small screwdrived in the hole directly below the ignition in the column. You will need to have the key in the ON position otherwise the ignition will not come out of the column.
dealer bring vin
The key is only available pre cut from the dealer. The dealer will also have to program it.
Accidents like breaking a car key in the ignition do happen. A person can use tweezers to remove the key piece or call a professional.
The relay could be stuck.
Perhaps a bad ignition switch
Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA
One to repair an ignition switch on your Astro Van is buy a replacement steering column from a local salvage yard including the ignition key, and replace the whole steering column. RC Houston, TX
Use a strap wrench around the base.