try removing the negative lead on the battery for about 30 min that will reset your computers
no
It is the ignition switch, remote keyless entry receiver, tire pressure monitor computer, antitheft chipped key computer
You mean, I think, ignition switch module, which is the location of the ignition switch.
Why is gasoline coming out of the ignition switch?
diagram colors to conest ignition switch
The neutral safety switch is bad, the ignition does not recognize it is in park. Your ignition switch may be bad.
no
It is the ignition switch, remote keyless entry receiver, tire pressure monitor computer, antitheft chipped key computer
You mean, I think, ignition switch module, which is the location of the ignition switch.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out and you can remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
My 1997 hombre will not start. How can I tell if it is the relay switches or the control module.
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
Are you using an original key, or a replacement that has the proper security computer chip located in the fat plastic part of the key? If not, the car's security system will keep the ignition locked and will not allow you to turn the ignition switch. ALSO: some earlier models of Focus had ignition switches that were a problem. If you ARE using the correct key and can't turn the switch to start the car anymore, the ignition switch may have to be replaced.
You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Why is gasoline coming out of the ignition switch?