0
What else can I help you with?
Where is the fuel pump inertia switch on a 1991 firebird?
None
What are some of the reasons why a 1996 Plymouth voyager would cut off while driving?
Fuel delivery problems such as a dirty fuel filter, a fuel pump going bad, a faulty fuel pressure regulator.
What type of gauge would you use to check fuel pressure?
I use a fuel pressure gauge.
Why would 96 Sebring have extremely rough acceleration and die if pedal depressed more than quarter in even tho injectors cleaned and new plugs and wires but runs fine if air temp is below 40 degrees?
Sounds like a fueling problem. Replace fuel filter, if problem persists, check fuel pressure. Good fuel pressure does not always mean your fuel pump is good. You need a fuel pressure tester with a relief valve. Connect tester, start and run engine. With engine running depress relief valve on tester. (make sure fuel runs into safe location). With relieve valve depressed, if engine dies, you are not getting enough volume, and need to replace your fuel pump.
Where is the fuel pressure regulater on a 2000 Grand Prix GTP?
it is mounted to the fuel injector rail where the high pressure comes from fuel pump and pressure is at a set psi per engine there is also a vacuum hose that raises the fuel pressure about 8-10 psi when load is applied on motor to give a boost of power
How do you relieve the fuel pressure on a 1998 Dodge Avenger?
Remove the gas cap and that will relieve pressure in the tank. There is a Schroeder valve on the fuel injector rail. Use that to relieve pressure at the injectors.
How do you replace fuel pressure regulator on 1999 Pontiac Firebird?
To replace the fuel pressure regulator on a 1999 Pontiac Firebird, first, relieve the fuel system pressure by removing the fuel pump fuse and starting the engine until it stalls. Disconnect the battery, then remove the intake manifold or the necessary components to access the regulator. Unplug the electrical connector and fuel lines from the regulator, then remove it from the fuel rail. Install the new regulator, reconnect the fuel lines and electrical connector, and reassemble any components you removed before reattaching the battery and testing the system for leaks.
Where is the fuel pressure regulator located on a 99' firebird?
The pressure regulator is located on top of the intake manifold on the fuel rail
How do you replace a fuel filter on a 1996 Cutlass Ciera?
It is located under the car on the frame just in front of the wheel. First you will need to relieve the fuel pressure. Then you will need to unscrew the fuel lines and remove it.
Where is the fuel pump located on a 1996 Pontiac firebird?
it is located in the gas tank.
Does a 5.7L have the same fuel tank as a 3.8L in a 1996 Pontiac firebird?
Yes
Your 1996 firebird still wont start after you replaced battery fuel filter and pump and is still getting low fuel pressure to where it wont start?
If you are certain it is low fuel pressure and you've changed the pump and filter the next thing would be the fuel pressure regulator. Also check to make sure none of the fuel lines are crushed closed.
How do you relieve fuel pressure on 95 S10 2.2l?
To relieve the fuel pressure on a Chevrolet S10, the fuel pump relay should first be removed. Then, the engine should be startedand run until it stalls.
What is the fuel pressure supposed to be on a 94 firebird v6?
Fuel pressure can range from 39 PSI to 52 PSI in a properly operating system.
How much fuel pressure is required for a 89 mpfi firebird 2.8?
the required fuel pressure for the 2.8 litre is 34-47 psi
How do you replace a fuel pump located on a 1996 infiniti I30?
the fuel pump should be located underneath the rear passenger seat but first you must disconnect the battery relieve the fuel pressure before you embark on removing it
Where is the valve to relieve pressure in fuel line?
The valve to relieve pressure in a fuel line, often called a Schrader valve or fuel pressure relief valve, is typically located on the fuel rail or near the fuel pump. It is used to safely release fuel pressure before servicing the fuel system. To relieve pressure, you can usually press the valve stem with a small tool, allowing fuel to escape into a rag or container. Always ensure safety precautions are followed to prevent spills or fire hazards.
