The clips at the top of the mirror should just slide up, allowing you to tilt the mirror toward you and lift it from the bottom clips.
You will need to remove the inside door panel of your 2002 VW Jetta. Remove the wiring harness from the mirror. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
Remove the trim panel and there are screws that hold the mirror on inside the door. Go to this website. It will show how to remove the door panel and the mirror assembly. Only go to step 12. The rest is for installing their mirror. Do the reverse when reinstalling. kwmuth.com
First remove door panel, then there will be 3 nuts by mirror fixture securing it to door. Don't forget electric connectors. Remove and replace as needed.
REMOVE SQUARE PLASTIC PLATE(I USED A STANLEY BLADE)TO REVEAL 4 XPLY SCREWS ,NO NEED TO REMOVE JUST SLACKEN THEM AND PULL MIRROR YOURS T,C U/K
It could be mould. If you don't turn on (or you don't have) a fan in the bathroom to remove steam, condensation can be left on the walls and black mould can grow where it is wet.
A garden tub can be installed in a pre-existing bathroom. You have to remove the pre-existing bathtub and install the garden tub.
on top of door panel behind the mirror. remove the plastic cover by prying it off. remove the mirror nuts, and then remove mirror. if it has mirror adjustment cables on it. just remove these cables, and put on with new mirror if needed.
Remove the inside door panel. Remove the wiring harness from the mirror. Remove the mirror retaining bolts. Reverse the process to install the new mirror.
The message appears because the oils on your finger causes the condensation to form at different temperatures than uncoated glass. To "erase" a message, wash the mirror with Windex.
To remove a glued on bathroom light fixture from a mirror, the best product to use is WD-40. Spray on the WD-40 and wait a few minutes while holding up the light fixture so it will not suddenly fall. Gently pull on the light fixture while using a putty knife to scrape the area underneath the lamp next to the mirror. Glue residue can also be cleaned up with the WD-40 after the fixture releases.
What's a "spot mirror" and where do you want to remove it from?
remove door panel then remove screws behind mirror. remove door panel then remove screws behind mirror.
I'd personally leave it to a professional, but if you insist on doing it yourself, just remove the screws holding it in, remove the electrical wires carefully, then connect wires to new side mirror and install the new one exactly the opposite of how you un-installed the defected side view mirror.
You need warm water to remove a sticky mirror from the locker.
Switching a light fixture requires the following steps. First, remove the old fixture. Second, you must disconnect the wiring. Third, a junction box must be installed. Finally, a new fixture must be installed. Detailed instructions can be found here: http://www.diynetwork.com/how-to/replace-a-bathroom-light-fixture/index.html
you must remove the outer fairing,remove headlight ring,windshield srews,and four screws from inner fairing,you will seee locator hole and plastic fastener for bracket,installation reverse blah blah blah. RIDE HARD
Passenger mirror access is same as drivers side. Three screws accessible inside door panel to remove entire mirror assembly. To remove mirror within the mirror assembly it just pulls off - snap fit of mirror mount to drive.