i have 89 gle it was doing the same thing , and it was the fuel injetor relay (black 1 undre the hood) I have a 1991 740 which suffers from no start when hot (engine turns fine). Apparently, and this is from a Volvo trained mechanic I'd trust with my life, the fault in these earlier models lies with the fuel pump relay (which he's replacing in a few days). The relay lies behind and slightly above the fuses which are accessed from behind the ashtray, and in an emergency may respond by being tapped a couple of times. Otherwise wait for around 20 minutes and try again.
According to the Ripoff Report, the MTC Volvo Group Inc. is a scam. The company has had various complaints over the years.
i have the same problem with my 91 Volvo 940SE Turbo, when i am turning a corner too fast, or to tight. i think it is just to much strain on the wheels and the motor, i tend not to turn so fast around corners. does your Volvo start right up when you pulled it over, after it has stalled? i think many people have the same problem. you can email me at: britishconcorde@yahoo.com
teeth on fly wheel may be rounded or teeth on stearter drive are rounded.
Its 1 of two things. Bad chip in key, or its the antenna that goes in a circle around the key hole to read the chip in the key. It will get worse and worse until one day it will never start again.
ignition switch...baterry cables...starter...ALARM????
My volvo s80 1999 model suddenly turned off and wont start. How do i detect theproblem
Sounds as though it needs to be serviced. Take it to a Volvo garage and get them to service and repair it.
Why does my car kick over but wont start?
To get a 1990 Corvette to start if it turns over and the battery is good, check to ensure the fuel filter is not clogged. You also need to ensure it has plenty of gasoline.
My manual says 3500lbs with a 300lb tongue weight. I personally wouldn't tow anything over 2500 lbs with a 240.
To effectively repair a fiberglass bathtub, you can start by cleaning the damaged area, sanding it down, applying a fiberglass repair kit, and then sanding and painting over the repaired area to match the rest of the bathtub.
To repair ripped drywall, you can start by cleaning the area, applying a mesh patch, covering it with joint compound, smoothing it out, and then painting over it to match the rest of the wall.
check the battery and connections/cables
To effectively repair a ceiling crack, you can start by cleaning the area, applying a joint compound or patching material, smoothing it out, and then painting over it to match the rest of the ceiling.
To effectively repair a wall crack in your home, you can start by cleaning the area, applying a patching compound, smoothing it out, and then painting over it to match the rest of the wall.
Not necessarily (although it is possible).I had the same problem with my Volvo in which the car would start then stall (and I had a full tank of gas!!!).
To repair a fiberglass tub, you can start by cleaning the damaged area, sanding it down, applying a fiberglass repair kit, and then sanding and painting over the repaired area to match the rest of the tub. Make sure to follow the instructions on the repair kit carefully for best results.