This list is specific to the 1992 Cherokee with the 4.0l I6 engine- hope it helps: loosen and remove the belt(s) Unbolt the exhaust/intake manifolds (there are 13 bolts i think... maybe 15) and discard the gasket- one bolt goes through the Power Steering mount unbolt the valve cover about 15 bolt unbolt the head (all remaining bolts on the top, and going in sideways from the AC compressor discard head gasket, and clean ALL gasket mating surfaces Put it all back together. MAKE SURE you follow the manual's bolt torquing pattern!!! otherwise you just did a bunch of work for nothing. By removing the head and replacing the gasket.
The 1985 Toyota Camry oil pressure sender is located on the left-hand side of the engine. The oil pressure sender will be just above of the oil pan.
diagram of replacing a modulator valve for a 1985 Chevy suburbun van
cannot get old ribbon rfom slide
you need to give more info!!..example what are you going to do with the 460?..race it?..pull a boat?..ton truck??
Dead battery. Recharge it and see if it will start. If not, remove the battery and go have it tested.
By removing the oil pan and cleaning the surface and installing a new gasket.
40psi +/- 5
25mpg
go ask jenai weber
1985 22RE Toyota 4x4 SR5 Xtra Cab
It is built into the alternator It is all 1 unit. Replace alternator.
The intake and exhaust manifolds, along with the timing belt will have to be removed to gain access to the head. Remove the head and replace the gasket. Torque the bolts down to the manufacturer specs and in the order Nissan suggests.
yes it should fit considering that the motormounts are the same on most Toyota trucks. Also make sure the motor you are putting in came out of a truck with the same type of transmission either manual or automatic.
its a roll over toy that will run forever if babied get the pitcure
how do I replace the seal on a 1990 Toyota 4x4 pick up, where the transfer case meets the exterior housing of the manual transmission?
replace wiper motor or gear box
The 1985 Toyota Corolla has one.