The bulb assembly needs to be removed from the front of the vehicle. Open the hood, and you will see that the entire plastic headlight assembly is held in place by a few hex head screws. Once these are removed the entire assembly can be lifted out, giving you access to the lamp socket. Replace the lamp (bulb)and reinstall. NOTE _ Be careful not to drop the screws in between the radiator and the grill, as they are hard to retrieve and usually get stuck on the body panel below the bumper. **you can actually avoid taking out the entire headlight if you just remove anything in the way of reaching behind the assembly. on the right side, it would be the fuse box, on the left side you can probably just reach behind if your hands aren't too large. then remove the rubber seal by prying it off. there is a spring clip that holds in the bulb, remove that by sliding it out from behind the bulb, then remove the bulb and replace.
check for bare wires or short in the wiring to the rear lights
Any Prizm or Corolla auto trans from 93 to 97. The 1.6 or the 1.8 housings are all the same. Just make sure if it is a 3 or 4 spd auto. It is a 6 hour job.
I would recommend 5w-30
4 quarts
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
the headlight assembly needs to come out in order to change the bulb ive had to do that to my 98 as well.
To change the headlight on a 2001 Chevy Prizm, first, open the hood and locate the headlight assembly. Disconnect the electrical connector from the back of the headlight bulb, then twist and remove the bulb from the socket. Replace it with a new bulb, making sure not to touch the glass with your fingers, and reattach the electrical connector. Finally, test the new headlight to ensure it works properly before closing the hood.
yes
It is behind the headlight on some cars.
It is located under the hood inside the radiator hose.
Type your answer here... where is the coolant sensor ona 2001 chevy prizm
I believe that it is under the radio in the dash
Go to your Chevy dealer parts department; they can print a copy for you.
It is located inside the gas tank. Dealer once quoted $500 to replace the entire tank unit. It is located inside the gas tank. Dealer once quoted $500 to replace the entire tank unit.
To replace the blower motor resistor on a 2002 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the lower dashboard panel to access the resistor, which is typically located near the blower motor. Disconnect the wiring harness from the resistor, unscrew it from its mounting position, and replace it with the new resistor. Finally, reassemble the dashboard panel and reconnect the battery terminal.
i http://wiki.answers.com/Q/You_went_now_where_thermo_located_in_chevy_prizm_2001
The fuel filter is located inside the tank.