The pulley is a press fit. If it no longer fits tight you need to replace it with a new one. This procedure requires special tools to remove and install the pulley to the pump. Some auto parts stores will rent the tools you need to do the job if you buy the parts from them.
You can rent or purchase the tool to properly remove and replace the Power Steering pulley from your local auto parts store. Without the proper tool you will damage the pulley or the pump or both.
That is not a Allen screw in there. That is part of the pump shaft. If you are looking to remove the pump pulley you will need a power steering pulley puller. This tool will help you remove it and replace it, without the puller you will damage the pulley or the pump or both.
LOSTEN BOLTS U WILL SEE A SQUARE HOLE WILL FIT A 1/2 INCH RATSHIT (LAL} & U USE THAT 2 TENSION BELT THEN TIGHTEN BOLTS
I a 97 pick up and the power steering pully is pressed on and pressed off
I need help on how to remove my powersteering pump? You must first remove the power steering pump pulley. Most part stores have a tool loaner program so you can borrow the puller and and return it and get your money back. After the pulley is removed there are 3 bolts holding the power steering pump to the bracket. Pull those and the long bracket that is on the back of the pump and connects to the exhaust manifold and alternator and the pump should slide out. This information is for a 5.7L engine, but I believe it is close to the same for a 4.3L.
Most cars now have a serpentine belt that drive the alternator, water pump, power steering unit, etc. The belt tension pulley is a spring loaded pulley that keeps the proper tension on all these units. It can be moved to release the tension in order to remove the belt.
That requires the use of a power steering pulley PULLER. ( A special tool ) The pulley is pressed on.
The power steering belt has an adjustment pulley. To tighten the belt on a 1994 Acura Vigor loosen the adjustment pulley and pull it up higher than tighten it.
How do you put the pulley back on the power steering pump on a 1990 suburban
Begin by loosening the tensioner pulley. Slide the tensioner pulley to the right. The power steering belt will become loose and can be removed. Put the new power steering belt on and tighten it by sliding the tensioner pulley to the left.
This requires a power steering pulley puller. This puller is designed to remove and install a power steering pulley without damage to the pulley and or pump. Attempting to do this without the puller will result in damaging the pulley or the pump or both.
You will have to get a tool called a Power steering puller to remove the pulley. Then another tool that puts it back on.
Yes.
you will need a power steering pulley puller other than that its gravy
You will need to buy or rent or borrow a power steering pulley puller. Trying to remove and replace the pulley without the correct puller will surely damage the pulley and or the pump.
How do you remove power steering pulley on a 1990 ck truck
With a power steering pulley puller. Your local auto parts store should have one you can rent or buy.
That pulley is a press fit type. There are not any threads. You will need to rent/buy some pullers for that power steering pulley.