Suzuki Bandits have an automatic cam chain tensioner. No manual adjustment is necessary or possible.
timing chain it,s the same engine as my wifes corsa auto
The 2003 2.5 CRD Jeep Cherokee has a cam belt not a chain
Broken cam or timing chain is the most likely cause.
The cam chain tension on a 1996 Saturn SL1 cannot be reset from outside of the motor. It will have to be accessed inside the motor. It is also a good idea to check and make sure it is not simply a broken timing guide.
To adjust the cam chain on a ct110 there is a little locknut and screw on the left hand side below the gear lever, it looks the same as the clutch adjuster on the opposite side. to adjust have the engine at idle at normal operating temperature then to adjust cam simply loosen the locknut then loosen the center bolt with your screw driver and tighten back up. this allows an automatic spring inside to retention the chain. if the chain still sound noisy to you then it made need to have the actual spring tightened up. it is a very simple task and you cannot break anything in doing so. on the bottom next to the sump plug there is another plug with an 14mm head, undo it and inside there will be a screw, just screw that up , it doesn't matter how far but i usually do it up all the way just to be safe. put the plug back on and loosen the adjuster nut and repeat above.
Chain
The 1.2 petrol engine is chain cam.
It is beside your cylinder. if you take your cylinder heads off you'll see a spring and the cam chain looped around it
The cam chain on xr250's are adjusted automaticly by a mechanism inside the engine, so there is no way to manually tighten it. If your engine is making a rattling sound, then your cam chain may need replacing as they do wear out over time which makes them longer
This is how you tighten a loose cam chain. On the honda 185s three wheelers there is a cam chain tensioner on the motor. First you need a 14mm wrench and a 10mm wrench and a screw with a fine thread now to get started you take the rubber boot off. Then you take the 10mm bolt off you put the fine thread screw in the hole. Then you start the motor up and loosin the 14mm locking nut while you do that you push down and lift up on the screw but hold the screw up and then tighten the locking nut and you should have the cam chain tightened.
To tighten the cam chain on a 1995 Kodiak 400 4x4 ATV, first remove the left side engine cover and inspect the cam chain tensioner. Adjust the tensioner by turning the adjuster bolt clockwise to increase tension, ensuring the chain has no slack. After adjustment, rotate the engine manually to check for any binding or excessive tension before reassembling the cover. Always refer to the service manual for specific torque specifications and procedures.
cam chain
The 2012 Suzuki Kizashi has double overhead cam (DOHC).
The 2013 Suzuki SX4 has double overhead cam (DOHC).
The 2012 Suzuki SX4 has double overhead cam (DOHC).
The 2010 Suzuki Kizashi has double overhead cam (DOHC).
The 2009 Suzuki SX4 has double overhead cam (DOHC).