2
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
The Camshaft Position Sensor (CMP) on the 4.7L V - 8 engine is bolted to the under side of the right cylinder head at the very front of the motor. It can Not be seen by looking at the engine from the top with the hood open. Access is from the bottom or possibly from the passenger side wheel well with the plastic splash guard removed.
You didn't say if it was a 6 cylinder or an 8 cylinder but it doesn't really matter because all the O2 sensors are located in the exhaust sytem and can be seen and replaced from under the vehicle.
hey Zim==I think it is in the dist on this engine. GoodluckJoe If your standing in front of the car its on the front of the moter where the trany and moter meet behind the exaust its a pain really tight space, best to go from under the car i have a lift and i still had a tough time.
Check the throttle position sensor (TPS)
where is the camshaft sensors located on Mercedes 2002 1800cc engine
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
The camshaft position sensor on a 2002 Mitsubishi Gallant is located behind the rear camshaft bearing. It constantly updates the vehicle' computer about the status of the camshaft.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
show location of camshaft position sensor for 2002 Oldsmobile bravada.
It would bolt in, but will not run. The tone rings for the camshaft and crankshaft position sensors are different.
The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
Camshaft position actuator A bank 2 usually means change the camshaft position sensor
Some common problems are, window regulators, vanos seals, camshaft position sensors, MAF's sensors, coolant expansion tanks exploding, and that's about it. Other than some common problems, they are great cars.
The 2003 Saturn L200 does not have a camshaft position sensor.
Above the timming cover