It's possible it was what is called an Iridium Flare. [See related question]
There was one predicted for 20:23 on the 27th November at an altitude of 15o so it's quite possible that is what you saw.
See related question and link for more information.
Normally on a digital small camera like the Nikon Coolpix S220 there is a power button and by that power button should be a small light, once plugged in the light should switch on and go red or green (sometimes yellow, amber or blue its depends on the company) If there is no light anyway that indicates anything then i suggest to search the brand and type of camera it is online or it might say something about the charging light in the manual... Hope this helps!
Transmission, maybe. Check engine light
Cyan is an equal mix of blue and light green.
Old flash bulbs contained a lot of jumbled tungsten, zirconium or aluminum wire housed in an oxygen atmosphere that was rapidly burnt when the shutter was clicked. Early amateur cameras supplied the current by battery. Later, simple point and shoot cameras like the Kodak Instamatic used something other than a battery (probably a piezoelectric device like a barbecue starter, but I'm just guessing). The bulbs were blue coated to balance the light for color film, and some contained a blue dot to indicate the oxygen had not leaked out and been replaced by air. If an air contaminated bulb was used, it usually exploded. Some cave photographers prefer the flash bulb to an electronic strobe, claiming the quantity of light output is superior. However, bulbs are getting harder to find.
BLUE!!!!! ----- The color (hue) will be a blue, but it depends on how your mixing what color you finally get. If mixing subtractively (like inks on paper) your colors are filtering the light that reflects off the page (we'll assume the light and the page is white). In this case "light blue" is a transparent blue and dark blue is blue and black, so the white light in the room will be both filtered by the pale blue and the dark blue. The pale blue removes some of the light which isn't blue, the dark blue removes a lot of the light - even some blue. None of this puts any light back, so the dark blue would dominate - you would get dark blue. If you were mixing light (additive mixing), dark blue is just a small amount of (dim) blue light and light blue is blue light with a bit less of all other colours in it (white). What you get then is the light blue, with just a little extra blue in it. Imagine a room in daylight and switching on a blue light-blub - would you notice the room becoming more "blue"? You'd probably still call it light-blue. If mixing opaque paints and you took a pale blue (blue+white) and very dull blue (blue+black) you would get a cool-blue-gray. You certainly wouldn't get back to a spectrum (saturated) blue.
its just more and less light same person if its dark u need the flash so u are not blacked out beaus no light is bouncing off u into the camera with out it and no light means black basically u need light to see and so does ur camera and the flash provides that light when u need it its always u
An imaging radar works very like a flash camera in that it provides its own light to illuminate an area on the ground and take a snapshot picture, but at radio wavelengths. A flash camera sends out a pulse of light (the flash) and records on film the light that is reflected back at it through the camera lens. Instead of a camera lens and film, a radar uses an antenna and digital computer tapes to record its images. In a radar image, one can see only the light that was reflected back towards the radar antenna.
The 430EX external flash seems like it would be the best candidate for the external flash for the Canon digital camera.
yes the flash can sting you like a bee, and it can harm you.
Yes, electricity can pass through a flashlight of a camera. The flashlight in a camera works by converting electrical energy into light energy to produce a flash. The circuitry within the camera controls the flow of electricity to the flashlight when triggered.
A shine of sudden light refers to a brief, intense burst of brightness that illuminates a dark or shadowed area. It can come from sources like a flash of lightning, a camera flash, or a sudden spotlight, creating a dramatic and striking visual effect.
An arc flash is the dome shaped blue light over a welding spot and is very dangerous. You will not forget the first arc flash that you see properly as it feels like sand in the eyes.
The light of the camera penetrated through darkness like
I'm just going out on a limb here but I'm GUESSING that it is used to hold a camera or camera accessories like an attachable flash or different camera lenses.
To improve your photography in low light conditions, consider using a tripod to stabilize your camera, adjusting your camera settings such as ISO, aperture, and shutter speed, and experimenting with different lighting sources like flash or ambient light. Additionally, practice and patience are key to mastering low light photography techniques.
Your flash may not be working when you try to take photos due to a variety of reasons, such as low battery levels, a malfunctioning flash unit, or incorrect camera settings. It is recommended to check the battery levels, ensure the flash is enabled in the camera settings, and try troubleshooting steps like resetting the camera or seeking professional help if the issue persists.
The best flash for a GH4 camera would depend on your specific needs and preferences. Some popular options include the Panasonic FL360L and the Olympus FL-600R. It's important to consider factors such as compatibility, power output, and features like wireless capabilities when choosing a flash for your GH4 camera.