answersLogoWhite

0

Check the wheel bearings in that right rear.

Sad thing is they probably won't look worn or even feel gravelly, although there may be some play. When pressing in the new bearings make sure they go in dead square or they won't last long.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Art & Architecture

What wheels does the parking brake effect?

The Parking Brake has a couple of configurations, on some vehicles with rear disc brakes it will press the inside pad of the caliper and squeeze the pad against the brake rotor to engage, some vehicles have a small set of brake shoes inside the rear rotor hub which press against the hub and prevent it from turning when the brake lever is engaged. On vehicles with rear drum brakes, the parking brake causes the rear brake shoe on either side to press against the brake drum and prevent it from turning. Either configuration in on the rear wheels.Usually the rear axle. The parking brakes are also the emergency brakes, and if they were on the front, could render the vehicle unsteerable in an accident avoidance maneuver.Rear brakes. On some older cars they parking brake actually surrounded the drive shaft and when applied lock the drive shaft in place. Today the parking brake applies the rear brakes.


Could the rotors be that bad after installing new front brake pads on a 2002 Chevy Blazer when you are driving and apply the brakes it pulsates?

Either warped rotors or drums can cause pulsating. Apply the parking brake slowly while going about 15mph and see if t pulsates. If it does, it is the drums that need turning. If not, it is the rotors that need turning.


96 Ford ranger When applying the brakes the left turn signal comes on Left turn signal only works correctly when brakes are not in use?

It sounds like the posative brake light wire is shorted out with the left turnsignal light wire. These are easily accesable in the trunk and also as a result eazily damaged. Locate the damaged wires and tape them up. Hope this helps.


What is a bus slack adjuster?

slack adjuster is the adjuster on the brakes of vehicles with air brakes. these are used to adjust and take the slack out of the brakes caused by usual wear on the brakes


If you drive through water, your brakes may become slippery and ineffective To dry the brakes off?

apply your brakes gently as you accelerate