answersLogoWhite

0


Best Answer

Hey Lisa==The lines and hose come as an assembly. Get one and you will see what you have to take off. GoodluckJoe

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If the power steering hose has a pin hole do you just have to replace the hose or the line into the pump as well?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

How can I replace the power steering pump on an 1993 Toyota Camry wagon with v6 engine?

In replacing the power steering pump on a 1993 Toyota Camry wagon with V6 engine, make sure to replace the steering pressure hose and clamp also. The leaks on both the hose and the clamp are the cause of the broken power steering pump.


Where would the leak be if the power steering fluid leaks when turning hard left?

could be several places, power steering hose, rack and pinion (or steering gear box) or power steering pump.


How do replace the power steering hose on a 2000 Durango?

I meant, how do you get the rubber line changed that goes up behind the back o the engine and around to the pump. There is a rubber line that joins the p/s rack which I srewed off behind the engine. How do I get the lower part of the rack so I ca have this rubber section replaces?


After a power steering flush can other things happen to require further mechanical work such as replacement of power steering pump hose rack and pinion?

ALL RUBBER COMPONENTS (HOSES/BELTS) SHOULD BE REPLACE RIGHT ABOUT EVERY TWO(2) years.now your rack and pinion should only be replace if is going bad or if is already bad. For example once the inner bushings on your tie rods brakes or crack, the entire unit needs to be replaced. if the rack is leaking it needs to be replace Even if there is NO noticeable changes in your steering of the vehicle. This is done for SAFETY REASONS.


Where is the water pump on a 96 Pontiac Grand Am?

Remove the power steering pump hose. Remove the wiring harness from the power steering pump. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.

Related questions

How do you replace power steering hose on 99 venture van?

how do you replace power steering hose on 99 chev venture


Is it possible to tape over a pin hole in a power steering line?

No there is a lot of pressure in the hi pressure hose,you will need to replace hose.


How to replace a power steering hose on a 2001 Oldsmobile aurora?

how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine


How do you replace power steering hose on a Chevy c-1500 pickup truck?

how do replace a power steering hose on a Chevy c-1500 pickup truck


How do you change the power steering hose on a 93 geo prism?

How do you replace power steering pressure hose on a 1993 geo prizm


You have to replace the power steering hose is this a difficult task?

no, it just screws into the steering box and screws into the power steering pump, or it might use a hose clamp for the power steering pump, it just depends.


How do you replace power steering hose on 1994 Toyota Corolla?

No


How do you replace the power steering hoses in a 1999 Ford Contour 2.5 V6?

How to replace power steering hose in 1999 ford excort


How do you fix a power steering leak on a 1999 expedition?

Clean the power steering are real good check for where the leak is coming from and go from there. For example if a hose is leaking replace hose, if power steering pump seals are leaking replace pump, exc.


How do you fix a leaky power steering hose in a Ford truck?

you replace it


How much does it cost to replace power steering hose?

Depends on what vehicle you are asking about.


How do you replace power steering hydrolic hose on john deere 4300?

how do you remove a damage steering hydrolic hose on a john deer 4300, no room to work