0
My EGR valve stuck on my '90 Mustang. All I did was to remove it and use some spray Wynns Carb Cleaner to remove all the carbon deposits. That was a year ago and the engine has been smooth as silk from then on. It's an easy job - make sure when you put it back that the connections are clean and tight and the gaskets are leak-proof.
So go ahead, clean it - it's cheaper than a new one!
Also, be very careful with any chemical that you use to clean it - most are harmful if you breath them in.
What else can I help you with?
How can you tell if you have a bad idle speed control valve?
first check for battery voltage to the valve by probing the wires of the electrical connector with a volt-meter it should be about 10.5 volts if not it's probably bad.next remove the valve and check the pintle inside the valve ports for excessive carbon deposits clean the valve ports and pintle with carburetor cleaner and replace the valve if idle does not improve replace the isc valve with a new one.
Why replace the aortic valve with pig valve?
because the aortic valve is not functioning properly, i.e. prolapse
Can oil be sucked up into the intake through the PCV valve on acceleration but not at idle?
yes replace the PCV valve it cheep ,,
Where is the PCV valve on a 1996 Buick Park Avenue and how do you replace it?
It is in the intake behind the throtle body. Simply pull it out and replace it.
How do you replace the check valve for the air suspension on a mark 8?
The Mark 8 does not have a check-valve in the air suspension system. Each air spring has a solenoid valve, which controls fill and vent of the spring. There is a fifth in the suspension compressor itself, which controls venting the system. I discovered that the seat for vent valve was corroded in my compressor, which would then leak when the system was trying to fill. This resulted in the compressor running, but the car lowering. I was able to clean the seat up for a temporary repair, but ultimately replaced the compressor.
How do you replace EGR valve or clean it on 1997 Dodge Avenger?
Replace if failed.
Can you clean the Idle Control Valve rather than buy a new one?
no just replace the valve
How do you repair egr valve on 2001 Saturn sl2?
You clean or replace it.
What does error code 1404 mean in a 1999 Tahoe?
Get valve,clean it or replace it
Why is the toxic fume light on in your Clio 1.4?
you have to clean or replace the EGR valve
How do you clean EGR valve 05 Chrysler 300?
It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.
Can you clean the PCV valve on a 1991 Chevy Silverado Diesel 6.2 Liter or do you have to replace it with a new one?
Yes, you can clean the PCV valve. Take off the PCV valve and get a spray can of carb cleaner. Just spray into the valve and just enough to clean out any gunk that might be in there. You should hear it rattle when you shake the valve.
Volvo v40 will start but will not idle. Why?
You need to clean (or replace - $200) the idle air valve.
High idle Toyota 4 runner?
clean or replace your idle air control valve.
How can I replace a bathtub faucet valve?
To replace a bathtub faucet valve, you will need to turn off the water supply, remove the old valve by unscrewing it, clean the area, and install the new valve by screwing it in place. Finally, turn the water supply back on and test the new valve for leaks.
How do i replace the iac valve for 2000 impala?
The IAC is located on the throttle body. Simply unplug the dirty IAC and clean or replace the IAC.
Kia Optima idling problems?
Clean the throttle body or replace the idle air control valve
