answersLogoWhite

0


Best Answer

This wire is connected to the solenoid along with a wire going to the power distribution system (Fuse box), but the connection or split is after the fusible link on the wire comming from the alternator. On most vehicles, those connections are attached to the same solenoid bolt. The connection there at the bolt, is done there because the large Positive battery cable also comes to that bolt.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is the charging wire from the alternator to starter solenoid on a 92 Pont Transport one single 8 ga wire or does it split off to something else also?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Why will the starter fore your ranger work?

Starter problems can be caused by several things: Weak battery because of battery failure or alternator that is not charging the battery. Falty connection between the battery and the starter. Solenoid failure or bad connection on the solenoid. Starter failure. Neutral lockout switch failure. Bad connection between keyswitch and starter.


99 Sebring good alternator and battery that sometimes acts like it has a dead battery you hook jumpers to terminals starts right up and will do it the rest of the day can a this be your solenoid?

It could be poor battery connections, the starter,


Where is starter solenoid 2000 chevy?

The solenoid is on the starter.


Where is the Location of solenoid on 1999 dodge ram?

Starter solenoid? Follow the + battery cable it connects to starter solenoid


What does it mean when your car wont start and you replaced the starter?

Your alternator is not charging the battery. This could be caused by alot of reasons, such as; 1- the alternator, or built-in voltage regulator is bad. 2 - Your belt that drives the alternator is loose, of glazed. 3 - one of the cables, black(-) or red (+), is loose, or not tight at the battery, or the starter, or alternator. First, with a volt meter. Check battery voltage with engine off, and all accessories off, it should read around 12.5 -13v. Now start engine, and see if voltage output increases - say 14 - 14.5 volts, then put on all accessories with engine running, and should still read around 14v......, , This will tell you the alternator is good.....Tom.

Related questions

My alternator is not getting power from the battery The wiring from the battery to the solenoid and from the solenoid to the alternator is good is this a bad solenoid the car will start and run?

Check for a bad fusable link at alternator


Would a faulty battery cause a diesel to stall while driving?

No it cannot unless alternator is not charging the only power a diesel requires is for fuel cutoff solenoid


Why would a Ford F-150 not start and all you get is a clicking noise when you turn the key?

It could be solenoid, starter, battery, alternator not CHARGING the battery or corroded battery terminals.


Could this have something to do with the alternator if a 2000 Dodge Neon battery light comes on and the car seems to jerk cut out stall when you are traveling at high speeds?

Yes, this situation could have something to do with the alternator. It could also have something to do with the solenoid, and the spark plugs as well.


What causes the starter to click on a 1995 Serria?

My understanding is that you are hearing the starter "click" but it does not engage. If that is correct your answer is: Typically either 1. the battery isn't fully charged (either a problem with the charging system, something is running the battery down or the alternator isn't charging properly) 2. a poor electrical connection somewhere between the starter and the battery or 3. a problem with the starter or solenoid.


How do you install 1 wire alternator 1969 Mustang 351W?

If you have a new alternator its as simple as run the one wire to the solenoid. If you are converting the alternator to a one wire, you will need an external regulator. If you have a new alternator its as simple as run the one wire to the solenoid. If you are converting the alternator to a one wire, you will need an external regulator.


Where are fusible links on Ford Ranger?

Connected to the solenoid. It is the single chord connected to the bottom terminal of the solenoid and is connected to the chord coming from the alternator. A blown fusible link will cause typical bad alternator symptoms and not allow the battery to be charged by the alternator.


Where is the actuator solenoid located on a cat C15 engine?

The solenoid on a Caterpillar C15 diesel engine can be found on top of the alternator. The solenoid is held on by four screws.


How do you change the starter solenoid in a 2000 Ford Expedition?

will the solenoid in a car cause it to shut off like a bad alternator


Where do you connect the positive battery lead to the starter or the alternator?

Starter solenoid.


Why won't a 95 Pontiac transport won't start?

There are many reasons why a car won't start. Some of these reasons could be the lack of fuel, drained battery, bad starter, bad alternator or bad starter solenoid.


Why will the starter fore your ranger work?

Starter problems can be caused by several things: Weak battery because of battery failure or alternator that is not charging the battery. Falty connection between the battery and the starter. Solenoid failure or bad connection on the solenoid. Starter failure. Neutral lockout switch failure. Bad connection between keyswitch and starter.