0
My 96 ford windstar ac clutch isn't engaging is there a fuse or relay that i should check and where?
Wiki User
∙ 9y ago
There is a fuse and relay, under the hood in a fuse box. More commonly though, the system will have low Freon. there is a low Freon switch that shuts down the system if the pressure is too low.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Check the clutch fluid on a new beetle?
The VW Beetle does not have clutch fluid. There is not any fluid associated with the clutch. The transmission has transmission fluid.
Why does a 2001 ford windstar die when i turn the ac or the defrost on?
check the alternater Something to do with your electrical in your vehical so i think you should get that checked out right away or just don't use your ac or defrost and your vehical should be ok..
Where do you check the fluid level in the master clutch cylinder of a 1991 Ford Escort GT with a 1.8L engine?
The brakes and clutch share the same reservoir.
Should you be able to stop the cooling fan while the engine is running?
if fan is belt driven you have a worn fan clutch check where shaft enters clutch if there is any leaks or clumps of road grime sticking to fan clutch its lost its internal oil supply causing slippage some clutches will slip when engine is cold and automatically spin faster as temp rises this is called a thermostatically controlled fan clutch also w/engine off grab fan firmly and check for any play between blade and shaft replace as needed
What would make your clutch pedal to move up and down on its own in a 94 Saturn sl2?
is this moving when mobile , over bumps? check engine mounts, gear box mounts and also check that clutch slave cylander is secure and not loose
Why would a 2000 Chevy truck overheat with ac on?
Check to make sure the fan clutch is engaging.
What should be done to correct a clutch that will not disengage on a 1994 HD sportster?
A clutch not disengaging is usually a hydraulic issue. Check your clutch fluid. Then check your clutch master and slave cylinders for leaks.
What would cause a suzuki 600 to die when you put it in gear?
I am assuming you mean the Suzuki GSXR600 motorcycle. ANY motorcycle whose engine dies when you engage first gear MOST PROBABLY has a CLUTCH problem. Have the clutch tightened. To check whether the clutch is CLEARING the gear, do the following: 1. With the engine turned off, hold the clutch and put the motorcycle in first gear. 2. While holding the clutch, push the motorbike forward. If the rear tire allows the motorcycle to move forward, the clutch is engaging properly and clearing the gear. If the motorcycle won't budge with the clutch engaged, the clutch is not engaging properly. If the clutch has been tightened and is too hard to engage, you might want to have a mechanic open the motorcycle and check the clutch discs- they might be worn out.
Check ball location on a 1995 ford windstar?
how many check ball locations on a 1995 ford windstar
Your ac clutch will not engage what can you do to find what is wrong?
First, check the electric system, fuses, circuit breaker, and connection to the clutch assy. Chances are your refrigerant level is low and the low pressure cut out switch is preventing the clutch from engaging in order to protect the compressor. You can jump across the terminals at the overload fuse to check operation of the clutch but only for a short period of time in case your system is low on refrig/oil. Evacuate and recharge the system.
How do you check the clutch oil on a cr250 2001?
How do you check the clutch oil on a cr250 2001?
How do you adjust the clutch on 1998 Toyota Corolla?
Clutches of these years are sometimes not adjustable. You need to check your fluid levels in your master cylinder. If you think your clutch is out of adjustment you should take it to a mechanic and let him check it out.
How do you adjust the clutch on my 1999 vw beetle. The clutch is not fully disengaging and I beleieve it could be this. However this may be a hydralic clutch sooooo?
Did you check the Clutch fluid? It could be next to the Brake Fluid container. They should look similar but the Clutch container should be slightly smaller. Check your manual, I think my old Turbo TBird, I had to lift the clutch pedal to make up for wear. Is your clutch worn out? How old is it? You say MAYBE a Hydralic clutch? If it's not then you'll have to check your manual or buy a work manual to adjust it. It's usually not that hard. sorry buddy but this clutch it's not adjustable.which means you need a new clutch kit and have it replaced.
How do you replace a clutch on a Mitsubishi 3000GT?
check 3si.org or stealth316.com -- should be there. good luck!
What can the problem be when a 91 Nissan sat for a long time and the clutch pedal is stuck to the floor?
check your clutch fluid lines and your clutch fluid and also bleed the clutch and it should work just fine mine did the same thing and i had to replace a clutch line that was pinched
Where is the clutch reservoir on a Mazda mx3?
it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine
Your car wont shift into gear but it starts what can you do to fix it?
if its an auto transmission try putting your foot on the brake pedal before engaging a gear if its a manual/stick check clutch travel by pumping pedal, have helper look at clutch fork area on gearbox, should have over 1 inch travel. if not much travel check firewall area of cable (not hydraulic cutch) look out for movement in firewall (somtimes cracked/rusted) can be fixed easily...
