answersLogoWhite

0

You should be able to adjust the linkage on the tranny, any repair shop should be able to do this at a reasonable rate,or buy a Chilton repair manual,and do it yourself.Good luck ,toro2.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the 1998 Mazda b3000 evr solenoid located?

i have a 98 Mazda b3000 auto 4x4. where are the shift solenoids located


Where is the fuel filter located on a 1998 Mazda b3000?

On my 1994 B3000 pickup it is located inside the frame under the drivers side door.


Where is the daylight running light module located on a 1998 Mazda B3000?

I don't have an answer to the question but i would also like to know how to have daylite running lights on my 98 b3000.


What kind of transmission oil for a 1998 Mazda B2500 standard truck 2WD?

Rcommended manual transmission lubricant type: MERCON automatic transmission fluid - Haynes Repair Manual #36071, 1994-2005 Mazda Pick-ups B2300, B2500, B3000, B4000.


How do I fix my 1998 Mazda Millenia that won't find reverse sometimes unless I restart the car?

i have the same problem with my Mazda millenia 2001


What kind of engine does a 1998 Mazda b2500 single cab have?

The B2500 Series Mazda pick-up has a 2.5 L engine. FYI: B2000 = 2.0 L; B2500 = 2.5 L; B3000 = 3.0 L; B4000 = 4.0 L.


What would cause a 1998 Mazda B3000 to not start after it has been sitting The engine will turn over fine but it will not fire?

Spark plugs not producing enough spark. Battery doesn't have enough charge. Old fuel.


What is the spark plug wiring diagram for 1998 Mazda B3000?

The spark plug wiring diagram for a 1998 Mazda B3000, which features a 3.0L V6 engine, typically follows a specific firing order of 1-4-2-5-3-6. The cylinders are numbered from the front of the engine to the rear, with cylinder 1 being on the driver's side. The ignition coils are connected to the spark plugs in the order that corresponds to the firing sequence. For precise wiring details, it's best to refer to the vehicle's service manual or repair guide.


Where is the neutral safety switch on a 1998 Mazda 626 automatic trans?

right side under hood near batt in a box


What causes low gas mileage in a 1998 Mazda b3000?

Low gas mileage in a 1998 Mazda B3000 can be caused by several factors, including a dirty air filter, faulty fuel injectors, or issues with the engine's ignition system. Additionally, under-inflated tires and poor alignment can increase rolling resistance, further reducing fuel efficiency. Regular maintenance, such as oil changes and spark plug replacements, can also impact overall performance and mileage. Lastly, driving habits and excessive idling can contribute to lower gas mileage as well.


Can you bypass a fuel pump on Mazda b3000 1998?

Yes, you can bypass the fuel pump on a 1998 Mazda B3000 by directly supplying power to the fuel pump connector. However, this should only be done for diagnostic purposes, as bypassing the fuel pump can lead to fuel system issues or safety hazards. It's important to ensure the vehicle is off, and all safety precautions are taken to prevent fuel leaks or electrical shorts. If you're experiencing fuel pump issues, it's advisable to replace the pump rather than bypass it.


What would cause a 1998 SL2 Automatic not to drive in reverse when all other gears work fine and all fluids have been topped off?

My daughters 1997 Saturn SC2 coupe automatic transmission has no reverse? what would cause this?? and how can i fix it without replacing the transmission.